Bearing - BS2 2208 2CS HFH

70x125x31 mm

Spherical roller bearing 22214 CC SKF with a cylindrical bore for high radial loads and axial loads in both directions. Its self-aligning design accommodates misalignment and shaft deflection.

17x40x12 mm
Metal shields on both sides
Greater radial internal clearance

Single-row deep groove ball bearing 6203 2Z C3 SKF with non-contact steel shields on both sides and C3 radial internal clearance. Suitable for high-speed applications and arrangements where fits, temperature or load reduce the bearing's operating clearance.

65x120x32.75 mm

Single-row tapered roller bearing 32213 ZKL for high radial loads and axial load in one direction. The separable outer ring simplifies installation; the correct clearance or preload is set in conjunction with an opposing bearing.

40x80x23 mm

Single-row cylindrical roller bearing NU 2208 E DPI for high radial loads. The NU design allows axial displacement of the shaft relative to the housing in both directions; E denotes an increased-capacity internal design.

35x53.6x12.8 mm

Special single-direction thrust ball bearing 511Z35 ZKL for axial load in one direction. Separable design with a shaft washer, housing washer and ball-and-cage assembly; compare the full designation and dimensions before replacement.

45x85x23 mm

Double-row self-aligning ball bearing 2209 E2RS1TN9 SKF with contact seals on both sides and a polyamide cage. It accommodates slight misalignment and shaft deflection and carries radial loads together with light axial loads in both directions.

45x85x30 mm

Double-row angular contact ball bearing 3209 ZKL for combined radial loads and axial loads in both directions. A robust solution for arrangements requiring good rigidity and accurate shaft guidance.

25x33x20 mm

NK 25/20 INA needle roller bearing without an inner ring provides high radial load capacity within a very small cross-section. The needles run directly on a suitably hardened and ground 25 mm shaft raceway.

60x150x35 mm

Single-row deep-groove ball bearing 6412 N ZKL for radial and axial loads in both directions. The N design has a snap-ring groove in the outer ring; when replacing, retain the complete designation and verify the axial locating method.

35x72x17 mm

Double-row self-aligning ball bearing 1207 K ZKL with a 1:12 tapered bore. It accommodates slight misalignment and shaft deflection while carrying radial loads and light axial loads in both directions.