6032Z

Bearing - 626 2Z FAG

6 × 19 × 6 mm. is a single-row deep-groove ball bearing with two non-contact metal shields. Its versatile design supports radial load and moderate axial loads in both directions, while low friction makes it suitable for higher speeds. The shields help retain lubricant and limit the entry of larger contaminants. This is a general-purpose machine bearing, not a contact-sealed or watertight design.

Bearing - 6906 2RS EZO

30 × 47 × 9 mm. Thin-section, single-row deep groove ball bearing with contact rubber seals on both sides. The CN-clearance design with a steel cage combines compact dimensions with protection of the lubricant from ordinary contaminants.

Bearing - 623 ZKL

3 × 10 × 4 mm. single-row deep groove ball bearing in open design. A compact bearing for radial and moderate axial loads in both directions, intended for arrangements providing their own lubrication and protection.

Bearing - 6307 2RS1 SKF

35 × 80 × 21 mm. bearing for replacement use. Before ordering, compare the complete designation and verify the dimensions, design and fit with the original part. Confirm compatibility against SKF documentation and the requirements of the specific application.

Bearing - 61901 2RS ZVL

12 × 24 × 6 mm. Rubber seals on both sides.

Bearing - 6308 2RS ZVL

40 × 90 × 23 mm. Rubber seals on both sides.

Bearing - 3206 ZKL

30 × 62 × 23 mm. double-row angular contact ball bearing for combined radial and axial loads in both directions. Its compact design provides rigid and accurate shaft guidance.

Bearing - 6006 2RS ZVL

30 × 55 × 13 mm. Single-row deep-groove ball bearing with rubber seals on both sides. Check the complete designation and suitability for the specific application.