Bearing - 16007 SKF

6304 2Z C3 SKF deep-groove ball bearing is a single-row bearing with steel shields on both sides and C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and is suitable for higher-speed operation.

75x130x25 mm

Single-row cylindrical roller bearing NU 215 ZKL for high radial loads and accurate shaft guidance. The NU design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.

61903 2RS1 SKF deep-groove ball bearing is a single-row bearing with contact rubber seals on both sides. It carries radial loads and moderate axial loads in both directions, while the factory grease is protected against leakage and common contaminants.

6214 2RS NACHI deep-groove ball bearing is a single-row bearing with rubber seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage and common contaminants.

60x150x35 mm

Single-row deep-groove ball bearing 6412 N ZKL for radial and axial loads in both directions. The N design has a snap-ring groove in the outer ring; when replacing, retain the complete designation and verify the axial locating method.

Deep groove ball bearing 6012 SKF is a single-row bearing in an open design. It accommodates radial loads and moderate axial loads in both directions and is suitable for accurate shaft support.

The open construction has no integral shields or seals, allowing direct lubricant access but requiring a clean or externally protected environment and a correctly designed lubrication system.

61904 2RS EZO deep-groove ball bearing is a single-row bearing with contact rubber seals on both sides. It carries radial loads and moderate axial loads in both directions, while the factory grease is protected against leakage and common contaminants.

15x28x9 mm

Single-direction thrust ball bearing 51102 URB for carrying axial load in one direction. Its separable design simplifies installation of the individual washers and ball-and-cage assembly; when replacing, compare the complete designation, dimensions and load direction.

35x100x25 mm

Single-row cylindrical roller bearing NJ 407 ZKL for high radial loads with axial shaft location in one direction. The NJ design permits axial displacement in the opposite direction; when replacing, compare the complete designation and required internal clearance.

40x90x23 mm
Metal shields on both sides
Greater radial internal clearance

Single-row deep-groove ball bearing 6308 2Z C3 SKF for radial load and axial loads in both directions. Two non-contact metal shields retain lubricant with low friction; C3 clearance provides allowance for tight fits or elevated operating temperature.