Bearing - 22234 KMC3 ZKL

20x47x14 mm
Higher accuracy class P4

High-precision spindle ball bearing S 6204 C TA P4 GMN for precision arrangements carrying combined radial load and axial load in one direction. The complete C TA P4 design, pairing and required preload must be preserved when replacing it.

10x26x8 mm

6000 2RSH C3 SKF deep groove ball bearing has contact rubber seals on both sides and greater-than-normal C3 radial internal clearance. The seals protect lubricant and raceways, while C3 provides allowance for clearance reduction caused by fits or operating temperature.

25x33x20 mm

NK 25/20 INA needle roller bearing without an inner ring provides high radial load capacity within a very small cross-section. The needles run directly on a suitably hardened and ground 25 mm shaft raceway.

20x32x7 mm

61804 2RS1 SKF deep groove ball bearing has contact rubber seals on both sides, helping retain lubricant and protect the raceways against contamination and moisture.

50x90x21.75 mm

30210 GPZ single-row tapered roller bearing carries high radial load together with axial load in one direction. Its separable inner assembly with rollers and separate outer ring simplify mounting.

40x62x22 mm

Single-row cylindrical roller bearing NU 4908 DKF for high radial loads and free axial displacement of the shaft relative to the housing in both directions. The NU design has two guiding flanges on the outer ring and a flange-free inner ring.

35x55x20 mm

NA 4907 DKF needle roller bearing with machined rings and its own inner ring provides high radial load capacity within a small radial section. It is suitable where the shaft surface cannot be used directly as a precision raceway.

75x130x25 mm

Single-row cylindrical roller bearing NU 215 ZKL for high radial loads and accurate shaft guidance. The NU design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.

70x95x18 mm

Single-direction thrust ball bearing 51114 FAG for carrying axial load in one direction. Its separable open design simplifies installation of the shaft washer, housing washer and ball-and-cage assembly; the bearing is not suitable for radial load.

30x72x19 mm

1306 MGM double-row self-aligning ball bearing with a cylindrical bore aligns itself against the spherical raceway of the outer ring. It is suitable for arrangements where slight shaft-to-housing misalignment or shaft deflection may occur.

20x47x14 mm

Single-row deep groove ball bearing 16204 FAG in an open design for high speeds, low friction and radial plus axial loads in both directions. Suitable for compact arrangements with a 20 mm shaft diameter.