Bearing - 22316 EK SKF

Deep groove ball bearing 6012 SKF is a single-row bearing in an open design. It accommodates radial loads and moderate axial loads in both directions and is suitable for accurate shaft support.

The open construction has no integral shields or seals, allowing direct lubricant access but requiring a clean or externally protected environment and a correctly designed lubrication system.

Needle roller bearing HK 2012 CX is a thin-walled bearing with a drawn outer cup, cage and needle rollers. Its open-ended design without an inner ring provides high radial load capacity within a very small radial space.

The raceway is normally formed by a hardened and ground shaft surface; when the shaft cannot meet the raceway requirements, a suitable separate inner ring must be used.

30x47x11 mm

Single-direction thrust ball bearing 51106 N ZKL with a separable design for reliable transmission of axial load in one direction. The compact 511 series is suitable where axial installation space is limited.

28x58x16 mm

Single-row deep-groove ball bearing 62/28 FBJ JAPAN with a special 28 mm bore for radial and axial loads in both directions. The open design allows lubrication to be selected for the application; when replacing, compare the complete designation, dimensions and required clearance.

Insert bearing UC 204 ZKL is designed for matching bearing housings and units. Its extended inner ring is secured to the shaft by two set screws, enabling quick mounting.

The spherical outside surface facilitates alignment in the housing seat, while seals on both sides help protect the bearing interior from common contaminants.

NU 2205 URB single-row cylindrical roller bearing is a separable bearing for high radial loads. The NU design has two integral flanges on the outer ring and a flangeless inner ring, allowing axial displacement of the shaft relative to the housing in both directions.

60x110x22 mm

Double-row self-aligning ball bearing 1212 K ZKL with a 1:12 tapered bore. Accommodates moderate angular misalignment and shaft deflection; suitable primarily for radial load and limited axial load in both directions.

6000 2RS1 SKF deep-groove ball bearing is a single-row bearing with rubber seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage and common contaminants.

30x72x19 mm

Single-row cylindrical roller bearing NJ 306 FRB for high radial loads and axial location in one direction. The NJ design permits axial displacement of the shaft relative to the housing in the opposite direction; when replacing, compare the complete designation and required internal clearance.

1205 KINEX self-aligning ball bearing has two rows of balls, a cylindrical bore and a common spherical raceway in the outer ring. It accommodates angular misalignment between shaft and housing and operates with low friction, including at higher speeds.