Bearing - 30208 AP6 ZKL

50x90x20 mm

The 6210 N KINEX deep-groove ball bearing is a single-row radial bearing with a snap-ring groove in the outer ring. The groove simplifies axial location in the housing, while the deep raceways support radial loads and moderate axial forces in both directions.

This open, unsealed design is suitable for gearboxes, electric motors and industrial positions with a separate lubrication system.

6014 2RSR FAG deep-groove ball bearing is a single-row bearing with RSR contact seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage, dust and moisture.

Self-aligning ball bearing 2306 E 2RS1TN9 SKF has two rows of balls and a common spherical raceway in the outer ring. This design accommodates static and dynamic misalignment between the shaft and housing.

Seals on both sides help protect the bearing interior from contaminants. It is suitable for arrangements where shaft deflection or mounting misalignment can occur.

6304 2Z C3 SKF deep-groove ball bearing is a single-row bearing with steel shields on both sides and C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and is suitable for higher-speed operation.

Deep groove ball bearing 6205 2Z ZVL is a single-row bearing with non-contact metal shields on both sides. It accommodates radial loads and moderate axial loads in both directions.

The 2Z design helps retain lubricant and limits the ingress of common contaminants while maintaining low friction. The shields are not watertight and are not intended for direct exposure to liquids.

6213 C3 ZVL deep-groove ball bearing is an open single-row bearing with greater-than-normal C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and suits arrangements where interference fits or operating temperatures reduce internal clearance.

Insert bearing YAR 206 2F SKF is designed for bearing units and is secured to the shaft by two set screws in the extended inner ring. This arrangement provides quick and reliable mounting.

A contact seal and flinger on both sides help protect the bearing from contaminants. The design is suitable for both constant and alternating directions of rotation.

50x110x27 mm

The 6310 C 2HRS C3 FAG deep-groove ball bearing is a Generation C single-row bearing with contact seals on both sides and C3 radial internal clearance. It is grease-filled and normally requires no relubrication under suitable operating conditions.

Suitable for motors, pumps, fans, gearboxes and industrial drives requiring contamination protection and additional internal clearance for temperature or tight fits.

Cylindrical roller bearing NU 2210 ZKL is a single-row radial bearing with high load capacity. The NU design has two integral flanges on the outer ring and an inner ring without flanges.

It permits axial displacement of the shaft relative to the housing in both directions and is therefore primarily used as a non-locating bearing. It does not provide axial shaft location.

25x52x15 mm

High-precision spindle ball bearing S 6205 C 18 TA UP GMN for precision arrangements carrying combined radial load and axial load in one direction. The complete C 18 TA UP design, pairing and required preload must be preserved when replacing it.

45x85x30 mm

Double-row angular contact ball bearing 3209 ZKL for combined radial loads and axial loads in both directions. A robust solution for arrangements requiring good rigidity and accurate shaft guidance.