Bearing - 32011 X/Q SKF

6304-C-2HRS-C3 FAG deep-groove ball bearing is a Generation C single-row bearing with HRS contact seals on both sides and C3 radial internal clearance. It combines reliable grease protection with low friction and carries radial loads and moderate axial loads in both directions.

Cylindrical roller bearing NU 2210 ZKL is a single-row radial bearing with high load capacity. The NU design has two integral flanges on the outer ring and an inner ring without flanges.

It permits axial displacement of the shaft relative to the housing in both directions and is therefore primarily used as a non-locating bearing. It does not provide axial shaft location.

6310 2RS C3 ZKL deep-groove ball bearing is a single-row bearing with rubber seals on both sides and greater-than-normal C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage and common contaminants.

Four-point contact ball bearing Q 305 P63 DKF is a single-row angular contact bearing for axial loads in both directions. It provides bidirectional axial shaft location within a compact cross-section.

The P63 suffix combines P6 accuracy and C3 axial internal clearance. This version must match the application requirements and is not an automatic substitute for Normal accuracy or clearance.

6204 C3 KINEX deep-groove ball bearing is an open single-row bearing with greater-than-normal C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and suits arrangements where interference fits or operating temperatures reduce internal clearance.

6214 2RS NACHI deep-groove ball bearing is a single-row bearing with rubber seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage and common contaminants.

63/22 2RS KOYO deep-groove ball bearing is a single-row bearing with contact rubber seals on both sides. It carries radial loads and moderate axial loads in both directions, while the factory grease is protected against leakage and common contaminants.

40x62x22 mm

Single-row cylindrical roller bearing NU 4908 DKF for high radial loads and free axial displacement of the shaft relative to the housing in both directions. The NU design has two guiding flanges on the outer ring and a flange-free inner ring.

25x62x17 mm

Single-row cylindrical roller bearing N 305 ZKL for high radial loads and accurate shaft guidance. The N design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.

35x72x17 mm

Single-row cylindrical roller bearing N 207 ZKL for high radial loads and accurate shaft guidance. The N design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.

32208 FBJ tapered roller bearing is a separable single-row bearing for high radial loads combined with axial load in one direction. Two bearings in an opposed arrangement are normally used when axial location is required in both directions.

95x170x45.5 mm

Single-row tapered roller bearing 32219 E ZKL for high radial loads and axial load in one direction. The separable design simplifies mounting; the E suffix is part of the exact designation and must match the equipment documentation when replacing the bearing.