Bearing - 32226 J2 SKF

40x90x23 mm
Metal shields on both sides
Greater radial internal clearance

Single-row deep-groove ball bearing 6308 2Z C3 SKF for radial load and axial loads in both directions. Two non-contact metal shields retain lubricant with low friction; C3 clearance provides allowance for tight fits or elevated operating temperature.

70x125x31 mm

Spherical roller bearing 22214 CC SKF with a cylindrical bore for high radial loads and axial loads in both directions. Its self-aligning design accommodates misalignment and shaft deflection.

Insert bearing YAR 206 2F SKF is designed for bearing units and is secured to the shaft by two set screws in the extended inner ring. This arrangement provides quick and reliable mounting.

A contact seal and flinger on both sides help protect the bearing from contaminants. The design is suitable for both constant and alternating directions of rotation.

17x26x5 mm
Rubber seals on both sides

Thin-section ball bearing 61803 2RS MTM for compact arrangements carrying radial and axial loads in both directions. Rubber seals on both sides protect the grease from dust and moisture; when replacing, retain the complete 2RS designation.

15x28x9 mm

Single-direction thrust ball bearing 51102 URB for carrying axial load in one direction. Its separable design simplifies installation of the individual washers and ball-and-cage assembly; when replacing, compare the complete designation, dimensions and load direction.

45x85x30 mm

Double-row angular contact ball bearing 3209 ZKL for combined radial loads and axial loads in both directions. A robust solution for arrangements requiring good rigidity and accurate shaft guidance.

30x55x13 mm

Single-row deep groove ball bearing 6006 2Z FAG with non-contact metal shields on both sides. Low-friction design for radial and axial loads in both directions; compare the complete 2Z marking before replacement.

Needle roller bearing HK 2012 CX is a thin-walled bearing with a drawn outer cup, cage and needle rollers. Its open-ended design without an inner ring provides high radial load capacity within a very small radial space.

The raceway is normally formed by a hardened and ground shaft surface; when the shaft cannot meet the raceway requirements, a suitable separate inner ring must be used.

25x52x15 mm

High-precision spindle ball bearing S 6205 C 18 TA UP GMN for precision arrangements carrying combined radial load and axial load in one direction. The complete C 18 TA UP design, pairing and required preload must be preserved when replacing it.

38.1x72.238x20.638 mm

Timken tapered roller bearing set 16150/16284 comprising cone 16150 and cup 16284. Imperial TS design for high radial loads and axial load in one direction; separable components simplify mounting and adjustment.