Bearing - 6011 2RS ZKL

45x100x25 mm

6309 2RS1 SKF deep-groove ball bearing is a single-row radial bearing with contact seals on both sides. It carries radial loads and moderate axial forces in either direction. The 2RS1 design protects the internal rolling contact from contaminants and helps retain lubricant inside the bearing.

50x80x16 mm

6010 ROLLWAY deep-groove ball bearing is a single-row radial bearing in the slim 60 series for a 50 mm shaft. Deep raceways support radial loads and moderate axial forces in both directions with low friction. The open design suits clean, correctly lubricated assemblies or machines that provide separate external protection.

50x90x20 mm

CS 210 2RS NEU insert ball bearing is a sealed bearing with a 50 mm cylindrical bore and spherical outside surface for installation in a matching housing. Double 2RS contact seals protect the rolling contact area from dust and splashed water while retaining lubricant. When replacing it, also compare the shaft-retention method and housing profile.

32208 FBJ tapered roller bearing is a separable single-row bearing for high radial loads combined with axial load in one direction. Two bearings in an opposed arrangement are normally used when axial location is required in both directions.

40x90x23 mm

6308 FAG deep-groove ball bearing is a single-row radial bearing in the robust 63 dimension series for a 40 mm shaft. Deep raceways support radial loads and moderate axial forces in both directions with smooth running and low friction. The open design suits clean, correctly lubricated assemblies or machines that provide separate external protection.

30216 A ZKL tapered roller bearing is a separable single-row bearing for high radial loads combined with axial load in one direction. The A design offers increased load capacity and a higher limiting speed; clearance or preload is established during installation.

6213 2RSR ZVL deep-groove ball bearing is a single-row bearing with contact rubber seals on both sides. It carries radial loads and moderate axial loads in both directions, while the factory grease is protected against leakage and common contaminants.

50x90x20 mm

The 6210 N KINEX deep-groove ball bearing is a single-row radial bearing with a snap-ring groove in the outer ring. The groove simplifies axial location in the housing, while the deep raceways support radial loads and moderate axial forces in both directions.

This open, unsealed design is suitable for gearboxes, electric motors and industrial positions with a separate lubrication system.

2302 2RS CODEX self-aligning ball bearing has two rows of balls and a spherical raceway in the outer ring, allowing it to compensate for angular misalignment between the shaft and housing. Rubber seals on both sides protect the factory grease and the bearing interior against common contaminants.

20x52x15 mm

6304 Z ZKL deep-groove ball bearing is a single-row radial bearing with a non-contact metal shield on one side. It supports radial loads and moderate axial forces in both directions. The Z shield protects one side of the rolling contact while the open side permits lubricant access or machine-integrated sealing.

25x52x15 mm
FAG 7205-B-XL-2RS-TVP single-row angular-contact ball bearing in X-life design, with rubber seals on both sides and a polyamide cage.