Bearing - 6014 2RS URB

80x110x30 mm

Single-row cylindrical roller bearing NU 4916 V DKF for high radial loads and accurate shaft guidance. The separable NU design permits axial displacement of the shaft relative to the housing in both directions.

70x110x25 mm

Robust single-row tapered roller bearing 32014 AX KLF ZVL for combined radial and one-direction axial loads. Its separable design simplifies installation and allows precise adjustment of operating clearance or preload.

25x52x15 mm

6205 2RS CX is a single-row deep-groove ball bearing with rubber seals on both sides. It protects the lubricant and raceways from common contaminants while carrying radial and limited axial loads.

10x19x5 mm
MTM 61800 2Z thin-section single-row deep-groove ball bearing with non-contact metal shields on both sides for compact arrangements, low friction and protection from ordinary contaminants.

17x47x14 mm

6303 2RS SKF is a single-row deep-groove ball bearing with contact rubber seals on both sides. It supports radial and limited axial loads while protecting the lubricant and raceways in commonly contaminated operation.

30x55x17 mm

32006 JR DPI is a single-row tapered roller bearing for arrangements exposed to radial load together with axial load in one direction. Its separable design allows the inner ring assembly with cage and rollers to be mounted independently of the outer ring.

It is suitable for gearboxes, hubs, shafts and other precise industrial arrangements. Tapered roller bearings are normally used in opposed pairs when axial forces must be supported in both directions.

40x65x22 mm

NA 40 V ZKL is a full-complement needle roller bearing with an inner ring, dimensionally corresponding to type NKIS40. The V design uses a full complement of needles without a cage, providing high radial load capacity in a compact cross-section.

It is intended primarily for high radial loads at low to moderate speeds. The separate inner ring also permits use where the shaft cannot be prepared as a precision raceway.

10x30x9 mm

6200 2RS ZVL is a single-row deep-groove ball bearing with contact rubber seals on both sides. It supports radial and limited axial loads while protecting the lubricant and raceways in commonly contaminated operation.

20x35x10 mm

Single-direction thrust ball bearing 51104 P5 ZKL in the higher P5 accuracy class. Its separable construction is designed for axial load in one direction and precise rotating arrangements.

30x62x17.25 mm

30206 A KINEX is a single-row tapered roller bearing for combined radial and axial loads. Its separable design simplifies mounting and precise adjustment of clearance or preload.