Bearing - 61815 ZZ NEU

30x72x27 mm

Double-row angular contact ball bearing 3306 CX for combined radial and axial loads in both directions. This stocked item is specified with a width of 27 mm; compare it carefully with the original bearing before replacement.

40x80x18 mm

Single-row deep groove ball bearing 6208 N ZKL in open design, with a snap-ring groove in the outer ring. Suitable for radial and axial loads in both directions; the N suffix denotes the groove, not an included snap ring.

40x80x18 mm
Metal shields on both sides

Single-row deep-groove ball bearing 6208 2Z ROLLWAY for radial load and moderate axial loads in both directions. Non-contact metal shields retain grease with low friction and protect against ordinary dry contamination.

35x80x21 mm

NJ 307 URB single-row cylindrical roller bearing is designed for high radial loads and can also locate the shaft axially in one direction. Its separable construction allows the inner ring to be installed independently of the outer ring and roller assembly.

55x72x9 mm

Thin-section single-row deep groove ball bearing 61811 2RZ SKF with low-friction seals on both sides. It combines a compact radial section with low friction and carries radial loads plus axial loads in both directions.

70x95x18 mm

Single-direction thrust ball bearing 51114 FAG for carrying axial load in one direction. Its separable open design simplifies installation of the shaft washer, housing washer and ball-and-cage assembly; the bearing is not suitable for radial load.

14x22x20 mm

Needle roller bearing without inner ring NK 14/20-XL INA for high radial loads in a compact space. The 14 mm dimension is the under-roller diameter, not a conventional bore; a suitably prepared shaft surface forms the inner raceway.

35x80x21 mm

6307 Z ZKL deep groove ball bearing has a non-contact metal shield on one side. The shield limits the ingress of larger contaminants and lubricant loss while retaining low friction; the opposite side remains open.