Bearing - 6215 2RS ZVL

10x30x9 mm

6200 2Z DPI is a single-row deep-groove ball bearing with two non-contact metal shields. It supports radial load and moderate axial loads in both directions, while its low-friction design makes it suitable for higher speeds.

The shields help retain lubricant and limit the entry of larger contaminants. This is a general-purpose machine bearing, not a contact-sealed or watertight design.

25x42x9 mm

61905 2RS1 SKF thin-section deep-groove ball bearing with contact seals on both sides for compact arrangements and effective lubricant protection.

45x85x19 mm

1209 MGM is a double-row self-aligning ball bearing with a cylindrical bore. The spherical outer-ring raceway allows the bearing to accommodate angular misalignment and shaft deflection without excessive edge loading.

It is particularly suitable where perfect alignment between shaft and housing cannot be guaranteed. The bearing supports radial load and lighter axial loads in both directions.

40x90x33 mm

2308 MGM double-row self-aligning ball bearing with a spherical outer-ring raceway to accommodate misalignment and shaft deflection.

12x28x8 mm

Single-row deep groove ball bearing 6001 ZKL for common radial and moderate axial loads. Its versatile open design provides low friction, smooth running and straightforward relubrication.

75x115x20 mm

Single-row cylindrical roller bearing NU 1015 M DKF for high radial loads, rigid guidance and non-locating shaft arrangements. The separable NU design permits axial displacement in both directions.

5x16x5 mm

EL 5 SKF is a miniature single-row deep-groove ball bearing dimensionally corresponding to the 625 series. Its deep raceway design supports radial load and moderate axial loads in both directions.

The EL 5 designation shown does not specify shielding, sealing or internal clearance. Check the physical design and complete marking of the original bearing before selecting a replacement.

30x47x9 mm

Thin-section single-row deep groove ball bearing 6906 ZZ IBB with metal shields on both sides. Its compact cross-section, low friction and two-sided protection suit space-constrained rotating arrangements.

8x12x10 mm

HK 0810 SKF is a drawn-cup needle roller bearing with open ends. Its compact cross-section provides high radial load carrying capacity and stiffness; it is not intended to support axial load.

The bearing has no separate inner ring, so a suitably hardened and ground shaft surface normally forms the raceway. Correct shaft quality, housing fit and lubrication are essential for service life.