Bearing - 7022 CDGA P4A SKF

12x28x11 mm

Single-direction thrust ball bearing 51201 URB for carrying axial load in one direction. Its separable design simplifies installation of the individual washers and ball-and-cage assembly; when replacing, compare the complete designation, dimensions and load direction.

35x72x17 mm

Single-row deep-groove ball bearing 6207 N ZKL for radial and axial loads in both directions. The N design has a snap-ring groove in the outer ring; when replacing, retain the complete designation and verify the axial locating method.

17x26x5 mm
Rubber seals on both sides

Thin-section ball bearing 61803 2RS MTM for compact arrangements carrying radial and axial loads in both directions. Rubber seals on both sides protect the grease from dust and moisture; when replacing, retain the complete 2RS designation.

25x62x17 mm

Single-row cylindrical roller bearing N 305 ZKL for high radial loads and accurate shaft guidance. The N design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.

Deep groove ball bearing SS 6001 2RS CRB is a compact single-row 6001-series bearing with rubber seals on both sides. It is suitable for shaft arrangements carrying radial and moderate axial loads.

The double-sealed design helps protect the bearing interior from common contaminants. Before ordering, compare the complete designation, dimensions and operating requirements; the SS prefix is part of this specific variant designation.

50x80x20 mm

Single-row tapered roller bearing 32010 JR DPI for high radial load combined with axial load in one direction. Its separable design allows the inner ring with rollers and the outer ring to be mounted independently.

The 6210 2Z P6 ZKL deep-groove ball bearing is a single-row radial bearing with non-contact metal shields on both sides. The shields help retain lubricant and restrict common contaminants while maintaining low running friction.

Suitable for electric motors, fans, pumps, gearboxes, conveyors and other rotating equipment. The 2Z suffix denotes two metal shields; the bearing is not watertight. Accuracy class P6 provides tighter dimensional and running tolerances than the normal class.

Cylindrical roller bearing NU 306 ZKL is a single-row radial bearing with high load capacity. The NU design has two integral flanges on the outer ring and an inner ring without flanges.

It permits axial displacement of the shaft relative to the housing in both directions and is therefore primarily used as a non-locating bearing. It does not provide axial shaft location.

65x120x32.75 mm

Single-row tapered roller bearing 32213 ZKL for high radial loads and axial load in one direction. The separable outer ring simplifies installation; the correct clearance or preload is set in conjunction with an opposing bearing.

14x22x20 mm

Needle roller bearing without inner ring NK 14/20-XL INA for high radial loads in a compact space. The 14 mm dimension is the under-roller diameter, not a conventional bore; a suitably prepared shaft surface forms the inner raceway.