Bearing - 7218 C P4 SKF

35x72x17 mm

Single-row cylindrical roller bearing N 207 ZKL for high radial loads and accurate shaft guidance. The N design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.

6304 2Z C3 SKF deep-groove ball bearing is a single-row bearing with steel shields on both sides and C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and is suitable for higher-speed operation.

Deep groove ball bearing 6205 2Z ZVL is a single-row bearing with non-contact metal shields on both sides. It accommodates radial loads and moderate axial loads in both directions.

The 2Z design helps retain lubricant and limits the ingress of common contaminants while maintaining low friction. The shields are not watertight and are not intended for direct exposure to liquids.

6014 2RSR FAG deep-groove ball bearing is a single-row bearing with RSR contact seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage, dust and moisture.

Insert bearing UC 204 ZKL is designed for matching bearing housings and units. Its extended inner ring is secured to the shaft by two set screws, enabling quick mounting.

The spherical outside surface facilitates alignment in the housing seat, while seals on both sides help protect the bearing interior from common contaminants.

30216 A ZKL tapered roller bearing is a separable single-row bearing for high radial loads combined with axial load in one direction. The A design offers increased load capacity and a higher limiting speed; clearance or preload is established during installation.

555062 FAG special barrel roller bearing is an open single-row roller bearing with barrel-shaped rolling elements. Its robust construction is intended primarily for high radial loads; this special catalogue number must be matched completely to the original bearing arrangement.

NA 4906 V DKF needle roller bearing is a full-complement radial bearing with machined outer and inner rings. The high number of needles provides high radial load capacity in a small radial cross-section; the design is intended for carefully lubricated arrangements at moderate speeds.

61903 2RS1 SKF deep-groove ball bearing is a single-row bearing with contact rubber seals on both sides. It carries radial loads and moderate axial loads in both directions, while the factory grease is protected against leakage and common contaminants.

Cylindrical roller bearing NU 306 ZKL is a single-row radial bearing with high load capacity. The NU design has two integral flanges on the outer ring and an inner ring without flanges.

It permits axial displacement of the shaft relative to the housing in both directions and is therefore primarily used as a non-locating bearing. It does not provide axial shaft location.

51105 ZKL single-direction thrust ball bearing is a separable bearing for axial load in one direction. It consists of a shaft washer, housing washer and ball-and-cage assembly and is not designed to carry radial load.