Bearing - 7220 ACD P4A SKF

20x52x22 mm
Greater radial internal clearance

Double-row angular-contact ball bearing 3304 C3 ZKL for rigid arrangements under combined loads. It carries radial load and axial loads in both directions; C3 clearance provides extra allowance where thermal expansion or tight fits reduce operating clearance.

28x58x16 mm

Single-row deep-groove ball bearing 62/28 FBJ JAPAN with a special 28 mm bore for radial and axial loads in both directions. The open design allows lubrication to be selected for the application; when replacing, compare the complete designation, dimensions and required clearance.

Deep groove ball bearing 6006 2Z C3 ZVL is a single-row bearing with metal shields on both sides and C3 radial internal clearance. It accommodates radial loads and moderate axial loads in both directions.

The non-contact 2Z shields limit contaminant ingress while maintaining low friction. C3 clearance is greater than Normal and must suit the temperature, speed and fit; it is not an automatic substitute for standard clearance.

35x80x21 mm

NJ 307 URB single-row cylindrical roller bearing is designed for high radial loads and can also locate the shaft axially in one direction. Its separable construction allows the inner ring to be installed independently of the outer ring and roller assembly.

20x47x14 mm

Single-row deep groove ball bearing 16204 FAG in an open design for high speeds, low friction and radial plus axial loads in both directions. Suitable for compact arrangements with a 20 mm shaft diameter.

40x80x18 mm
Metal shields on both sides

Single-row deep-groove ball bearing 6208 2Z ROLLWAY for radial load and moderate axial loads in both directions. Non-contact metal shields retain grease with low friction and protect against ordinary dry contamination.

28.575x34.925x25.4 mm

GB 1816 TOR2S TORRINGTON full-complement drawn-cup needle roller bearing provides high radial load capacity within a very small radial section. This open design has no inner ring and uses a suitably prepared shaft surface as the raceway.

The 6210 2Z P6 ZKL deep-groove ball bearing is a single-row radial bearing with non-contact metal shields on both sides. The shields help retain lubricant and restrict common contaminants while maintaining low running friction.

Suitable for electric motors, fans, pumps, gearboxes, conveyors and other rotating equipment. The 2Z suffix denotes two metal shields; the bearing is not watertight. Accuracy class P6 provides tighter dimensional and running tolerances than the normal class.

6000 2RS1 SKF deep-groove ball bearing is a single-row bearing with rubber seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage and common contaminants.

60x110x22 mm

Double-row self-aligning ball bearing 1212 K ZKL with a 1:12 tapered bore. Accommodates moderate angular misalignment and shaft deflection; suitable primarily for radial load and limited axial load in both directions.