Bearing - AMS 12 SKF

38.1x72.238x20.638 mm

Timken tapered roller bearing set 16150/16284 comprising cone 16150 and cup 16284. Imperial TS design for high radial loads and axial load in one direction; separable components simplify mounting and adjustment.

30x72x19 mm

1306 MGM double-row self-aligning ball bearing with a cylindrical bore aligns itself against the spherical raceway of the outer ring. It is suitable for arrangements where slight shaft-to-housing misalignment or shaft deflection may occur.

35x80x21 mm

NJ 307 URB single-row cylindrical roller bearing is designed for high radial loads and can also locate the shaft axially in one direction. Its separable construction allows the inner ring to be installed independently of the outer ring and roller assembly.

40x68x19 mm

Single-row tapered roller bearing 32008 JR DPI for high radial loads combined with axial load in one direction. Its separable design simplifies mounting and allows running clearance or preload to be set in a paired arrangement.

17x26x5 mm
Rubber seals on both sides

Thin-section ball bearing 61803 2RS MTM for compact arrangements carrying radial and axial loads in both directions. Rubber seals on both sides protect the grease from dust and moisture; when replacing, retain the complete 2RS designation.

60x110x22 mm
Higher accuracy class P6

Single-row angular-contact ball bearing 7212 P6 ZKL for combined radial load and axial load in one direction. P6 accuracy is suitable for arrangements with higher requirements for dimensional and running accuracy.

35x55x20 mm

NA 4907 DKF needle roller bearing with machined rings and its own inner ring provides high radial load capacity within a small radial section. It is suitable where the shaft surface cannot be used directly as a precision raceway.

40x80x18 mm

6208 2RSR KINEX deep groove ball bearing has contact rubber seals on both sides, helping retain lubricant and protect the raceways against contamination and moisture.

50x90x21.75 mm

Single-row tapered roller bearing 30210 A P6X ZVL for high radial loads and axial load in one direction. The P6X tolerance version is intended for arrangements with higher accuracy requirements; the complete A P6X designation must match when replacing the bearing.

25x33x20 mm

NK 25/20 INA needle roller bearing without an inner ring provides high radial load capacity within a very small cross-section. The needles run directly on a suitably hardened and ground 25 mm shaft raceway.