Bearing - B7018 C ATB P5 ZKL

17x47x14 mm

Single-row deep groove ball bearing 6303 Z SRO with a non-contact metal shield on one side. A versatile design for radial loads and light axial loads in both directions, offering low friction and good speed capability.

28.575x34.925x25.4 mm

GB 1816 TOR2S TORRINGTON full-complement drawn-cup needle roller bearing provides high radial load capacity within a very small radial section. This open design has no inner ring and uses a suitably prepared shaft surface as the raceway.

45x75x20 mm

Single-row tapered roller bearing 32009 AX ZKL for high radial load combined with axial load in one direction. Its separable design allows the inner ring with rollers and the outer ring to be mounted independently.

60x110x22 mm

Double-row self-aligning ball bearing 1212 K ZKL with a 1:12 tapered bore. Accommodates moderate angular misalignment and shaft deflection; suitable primarily for radial load and limited axial load in both directions.

35x80x21 mm

NJ 307 URB single-row cylindrical roller bearing is designed for high radial loads and can also locate the shaft axially in one direction. Its separable construction allows the inner ring to be installed independently of the outer ring and roller assembly.

40x68x19 mm

Single-row tapered roller bearing 32008 JR DPI for high radial loads combined with axial load in one direction. Its separable design simplifies mounting and allows running clearance or preload to be set in a paired arrangement.

30x62x20 mm

NU 2206 BNA P62 ZKL single-row cylindrical roller bearing is designed for high radial loads and allows axial displacement of the shaft relative to the housing in both directions. P62 denotes P6 dimensional and running accuracy combined with reduced C2 radial internal clearance.

65x120x32.75 mm

Single-row tapered roller bearing 32213 ZKL for high radial loads and axial load in one direction. The separable outer ring simplifies installation; the correct clearance or preload is set in conjunction with an opposing bearing.

12x28x11 mm

Single-direction thrust ball bearing 51201 URB for carrying axial load in one direction. Its separable design simplifies installation of the individual washers and ball-and-cage assembly; when replacing, compare the complete designation, dimensions and load direction.

17x26x5 mm
Rubber seals on both sides

Thin-section ball bearing 61803 2RS MTM for compact arrangements carrying radial and axial loads in both directions. Rubber seals on both sides protect the grease from dust and moisture; when replacing, retain the complete 2RS designation.