Bearing - BT1 0705 Q SKF

40x68x19 mm

Single-row tapered roller bearing 32008 JR DPI for high radial loads combined with axial load in one direction. Its separable design simplifies mounting and allows running clearance or preload to be set in a paired arrangement.

17x47x14 mm

Single-row deep groove ball bearing 6303 Z SRO with a non-contact metal shield on one side. A versatile design for radial loads and light axial loads in both directions, offering low friction and good speed capability.

35x72x17 mm

1207 P6 ZKL double-row self-aligning ball bearing with a cylindrical bore accommodates slight shaft-to-housing misalignment. P6 accuracy provides tighter dimensional and running tolerances than the normal class.

90x160x40 mm

Spherical roller bearing 22218 CCKW33 SKF with a tapered bore and W33 relubrication features. It carries high radial loads and axial loads in both directions, while its self-aligning design accommodates misalignment.

50x110x27 mm

1310 ZKL double-row self-aligning ball bearing with a cylindrical bore can accommodate slight misalignment between the shaft and housing. The open design is suitable for radial loads and limited axial loads in both directions.

Rubber seals on both sides
Greater radial internal clearance
FAG 3004 2RS C3 bearing with precisely stated execution.

50x90x21.75 mm

Single-row tapered roller bearing 30210 A P6X ZVL for high radial loads and axial load in one direction. The P6X tolerance version is intended for arrangements with higher accuracy requirements; the complete A P6X designation must match when replacing the bearing.

20x47x14 mm

Single-row deep groove ball bearing 16204 FAG in an open design for high speeds, low friction and radial plus axial loads in both directions. Suitable for compact arrangements with a 20 mm shaft diameter.

70x95x18 mm

Single-direction thrust ball bearing 51114 FAG for carrying axial load in one direction. Its separable open design simplifies installation of the shaft washer, housing washer and ball-and-cage assembly; the bearing is not suitable for radial load.

30x72x19 mm

1306 MGM double-row self-aligning ball bearing with a cylindrical bore aligns itself against the spherical raceway of the outer ring. It is suitable for arrangements where slight shaft-to-housing misalignment or shaft deflection may occur.