Bearing - LM 241148 10 VE673 SKF

14x22x20 mm

Needle roller bearing without inner ring NK 14/20-XL INA for high radial loads in a compact space. The 14 mm dimension is the under-roller diameter, not a conventional bore; a suitably prepared shaft surface forms the inner raceway.

40x90x23 mm
Metal shields on both sides
Greater radial internal clearance

Single-row deep-groove ball bearing 6308 2Z C3 SKF for radial load and axial loads in both directions. Two non-contact metal shields retain lubricant with low friction; C3 clearance provides allowance for tight fits or elevated operating temperature.

40x80x23 mm

Single-row cylindrical roller bearing NU 2208 E DPI for high radial loads. The NU design allows axial displacement of the shaft relative to the housing in both directions; E denotes an increased-capacity internal design.

50x80x20 mm

Single-row tapered roller bearing 32010 X FAG with a separable design for high combined radial and one-direction axial loads. Compare the exact X variant with the original part; this product designation does not include XL.

35x72x23 mm

NJ 2207 ZKL single-row cylindrical roller bearing is designed for high radial loads and can also locate the shaft axially in one direction. Its separable construction allows the inner ring to be installed independently of the outer ring and roller assembly.

28.575x34.925x25.4 mm

GB 1816 TOR2S TORRINGTON full-complement drawn-cup needle roller bearing provides high radial load capacity within a very small radial section. This open design has no inner ring and uses a suitably prepared shaft surface as the raceway.

70x95x18 mm

Single-direction thrust ball bearing 51114 FAG for carrying axial load in one direction. Its separable open design simplifies installation of the shaft washer, housing washer and ball-and-cage assembly; the bearing is not suitable for radial load.

95x170x45.5 mm

Single-row tapered roller bearing 32219 E ZKL for high radial loads and axial load in one direction. The separable design simplifies mounting; the E suffix is part of the exact designation and must match the equipment documentation when replacing the bearing.