Bearing - N 210 M SKF

The 6210 2Z P6 ZKL deep-groove ball bearing is a single-row radial bearing with non-contact metal shields on both sides. The shields help retain lubricant and restrict common contaminants while maintaining low running friction.

Suitable for electric motors, fans, pumps, gearboxes, conveyors and other rotating equipment. The 2Z suffix denotes two metal shields; the bearing is not watertight. Accuracy class P6 provides tighter dimensional and running tolerances than the normal class.

NA 4906 V DKF needle roller bearing is a full-complement radial bearing with machined outer and inner rings. The high number of needles provides high radial load capacity in a small radial cross-section; the design is intended for carefully lubricated arrangements at moderate speeds.

50x90x20 mm

The 6210 N KINEX deep-groove ball bearing is a single-row radial bearing with a snap-ring groove in the outer ring. The groove simplifies axial location in the housing, while the deep raceways support radial loads and moderate axial forces in both directions.

This open, unsealed design is suitable for gearboxes, electric motors and industrial positions with a separate lubrication system.

6313 MP63 ZKL deep-groove ball bearing is an open single-row bearing with a solid brass or bronze cage (M), P6 accuracy and greater-than-normal C3 radial clearance (P63). It carries radial loads and axial loads in both directions.

30x62x20 mm

Rubber seals on both sides

The 62206 2RS1 SKF deep-groove ball bearing is a single-row bearing with contact seals on both sides. Its 30 × 62 × 20 mm dimensions, factory grease fill and effective lubricant retention make it suitable for compact, protected bearing arrangements.

HK 3520 CX drawn-cup needle roller bearing is an open-ended, thin-walled bearing without an inner ring. It provides high radial load capacity in a very small radial space; a suitably hardened and precision-ground shaft forms the inner raceway.

15x28x9 mm

Single-direction thrust ball bearing 51102 URB for carrying axial load in one direction. Its separable design simplifies installation of the individual washers and ball-and-cage assembly; when replacing, compare the complete designation, dimensions and load direction.

Cylindrical roller bearing NU 2210 ZKL is a single-row radial bearing with high load capacity. The NU design has two integral flanges on the outer ring and an inner ring without flanges.

It permits axial displacement of the shaft relative to the housing in both directions and is therefore primarily used as a non-locating bearing. It does not provide axial shaft location.

Deep groove ball bearing 6205 2Z ZVL is a single-row bearing with non-contact metal shields on both sides. It accommodates radial loads and moderate axial loads in both directions.

The 2Z design helps retain lubricant and limits the ingress of common contaminants while maintaining low friction. The shields are not watertight and are not intended for direct exposure to liquids.