Bearing - NU 2216 ECML P65 SKF

30x62x16 mm

NUP 206 E ZVL single-row cylindrical roller bearing carries high radial loads and locates the shaft axially in both directions through its flange arrangement. The E suffix denotes an optimized internal design with increased load capacity.

60x150x35 mm

Single-row deep-groove ball bearing 6412 N ZKL for radial and axial loads in both directions. The N design has a snap-ring groove in the outer ring; when replacing, retain the complete designation and verify the axial locating method.

20x47x14 mm
Higher accuracy class P4

High-precision spindle ball bearing S 6204 C TA P4 GMN for precision arrangements carrying combined radial load and axial load in one direction. The complete C TA P4 design, pairing and required preload must be preserved when replacing it.

70x95x18 mm

Single-direction thrust ball bearing 51114 FAG for carrying axial load in one direction. Its separable open design simplifies installation of the shaft washer, housing washer and ball-and-cage assembly; the bearing is not suitable for radial load.

60x110x28 mm

22212 ZKL double-row spherical roller bearing with a cylindrical bore carries high radial loads and axial loads in both directions. Its self-aligning design helps accommodate slight misalignment and shaft deflection.

28.575x34.925x25.4 mm

GB 1816 TOR2S TORRINGTON full-complement drawn-cup needle roller bearing provides high radial load capacity within a very small radial section. This open design has no inner ring and uses a suitably prepared shaft surface as the raceway.

35x72x23 mm

NJ 2207 ZKL single-row cylindrical roller bearing is designed for high radial loads and can also locate the shaft axially in one direction. Its separable construction allows the inner ring to be installed independently of the outer ring and roller assembly.

30x72x19 mm

Single-row cylindrical roller bearing NJ 306 FRB for high radial loads and axial location in one direction. The NJ design permits axial displacement of the shaft relative to the housing in the opposite direction; when replacing, compare the complete designation and required internal clearance.

70x125x31 mm

Spherical roller bearing 22214 CC SKF with a cylindrical bore for high radial loads and axial loads in both directions. Its self-aligning design accommodates misalignment and shaft deflection.