Bearing - NU 2216 ECP SKF

100x215x73 mm

Spherical roller bearing 22320 KM ZKL with a tapered bore and machined brass cage for high radial loads and axial loads in both directions. Its self-aligning design helps accommodate misalignment and shaft deflection.

20x47x14 mm

Single-row deep groove ball bearing 16204 FAG in an open design for high speeds, low friction and radial plus axial loads in both directions. Suitable for compact arrangements with a 20 mm shaft diameter.

Insert bearing YAR 206 2F SKF is designed for bearing units and is secured to the shaft by two set screws in the extended inner ring. This arrangement provides quick and reliable mounting.

A contact seal and flinger on both sides help protect the bearing from contaminants. The design is suitable for both constant and alternating directions of rotation.

1210 K ZKL self-aligning ball bearing has two rows of balls, a spherical outer-ring raceway and a tapered bore. It accommodates angular misalignment between shaft and housing and can be mounted directly on a tapered journal or with a matching adapter sleeve.

HK 1210 B INA drawn-cup needle roller bearing is an open-ended, thin-walled bearing without an inner ring. It provides high radial load capacity in a very small radial space; a suitably hardened and precision-ground shaft forms the inner raceway.

6008 2RS ZVL deep-groove ball bearing is a single-row bearing with rubber seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage and common contaminants.

40x68x19 mm

Single-row tapered roller bearing 32008 JR DPI for high radial loads combined with axial load in one direction. Its separable design simplifies mounting and allows running clearance or preload to be set in a paired arrangement.

Cylindrical roller bearing NU 2210 ZKL is a single-row radial bearing with high load capacity. The NU design has two integral flanges on the outer ring and an inner ring without flanges.

It permits axial displacement of the shaft relative to the housing in both directions and is therefore primarily used as a non-locating bearing. It does not provide axial shaft location.

40x62x22 mm

Single-row cylindrical roller bearing NU 4908 DKF for high radial loads and free axial displacement of the shaft relative to the housing in both directions. The NU design has two guiding flanges on the outer ring and a flange-free inner ring.

Single-row 32008 AX KINEX tapered roller bearing is a separable single-row bearing for high radial loads combined with axial load in one direction. Two bearings in an opposed arrangement are normally used when axial location is required in both directions.

25x62x17 mm

Single-row cylindrical roller bearing N 305 ZKL for high radial loads and accurate shaft guidance. The N design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.