Bearing - NU 2316 ECML C4 SKF

NU 2205 URB single-row cylindrical roller bearing is a separable bearing for high radial loads. The NU design has two integral flanges on the outer ring and a flangeless inner ring, allowing axial displacement of the shaft relative to the housing in both directions.

Cylindrical roller bearing NU 2210 ZKL is a single-row radial bearing with high load capacity. The NU design has two integral flanges on the outer ring and an inner ring without flanges.

It permits axial displacement of the shaft relative to the housing in both directions and is therefore primarily used as a non-locating bearing. It does not provide axial shaft location.

6204 C3 KINEX deep-groove ball bearing is an open single-row bearing with greater-than-normal C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and suits arrangements where interference fits or operating temperatures reduce internal clearance.

12x28x11 mm

Single-direction thrust ball bearing 51201 URB for carrying axial load in one direction. Its separable design simplifies installation of the individual washers and ball-and-cage assembly; when replacing, compare the complete designation, dimensions and load direction.

17x26x5 mm
Rubber seals on both sides

Thin-section ball bearing 61803 2RS MTM for compact arrangements carrying radial and axial loads in both directions. Rubber seals on both sides protect the grease from dust and moisture; when replacing, retain the complete 2RS designation.

90x160x40 mm

Spherical roller bearing 22218 CCKW33 SKF with a tapered bore and W33 relubrication features. It carries high radial loads and axial loads in both directions, while its self-aligning design accommodates misalignment.

Deep groove ball bearing 6006 2Z C3 ZVL is a single-row bearing with metal shields on both sides and C3 radial internal clearance. It accommodates radial loads and moderate axial loads in both directions.

The non-contact 2Z shields limit contaminant ingress while maintaining low friction. C3 clearance is greater than Normal and must suit the temperature, speed and fit; it is not an automatic substitute for standard clearance.

6014 2RSR FAG deep-groove ball bearing is a single-row bearing with RSR contact seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage, dust and moisture.

6022 2Z C3 FAG deep-groove ball bearing is a single-row bearing with steel shields on both sides and C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and is suitable for higher-speed operation.