Bearing - QJ 210 N2MA C4S1 SKF

20x32x7 mm

61804 2RS1 SKF deep groove ball bearing has contact rubber seals on both sides, helping retain lubricant and protect the raceways against contamination and moisture.

30x47x11 mm

Single-direction thrust ball bearing 51106 N ZKL with a separable design for reliable transmission of axial load in one direction. The compact 511 series is suitable where axial installation space is limited.

60x110x22 mm
Higher accuracy class P6

Single-row angular-contact ball bearing 7212 P6 ZKL for combined radial load and axial load in one direction. P6 accuracy is suitable for arrangements with higher requirements for dimensional and running accuracy.

20x47x14 mm

Single-row deep groove ball bearing 16204 FAG in an open design for high speeds, low friction and radial plus axial loads in both directions. Suitable for compact arrangements with a 20 mm shaft diameter.

28.575x34.925x25.4 mm

GB 1816 TOR2S TORRINGTON full-complement drawn-cup needle roller bearing provides high radial load capacity within a very small radial section. This open design has no inner ring and uses a suitably prepared shaft surface as the raceway.

30x72x27 mm

Double-row angular contact ball bearing 3306 CX for combined radial and axial loads in both directions. This stocked item is specified with a width of 27 mm; compare it carefully with the original bearing before replacement.

17x40x12 mm
Metal shields on both sides
Greater radial internal clearance

Single-row deep groove ball bearing 6203 2Z C3 SKF with non-contact steel shields on both sides and C3 radial internal clearance. Suitable for high-speed applications and arrangements where fits, temperature or load reduce the bearing's operating clearance.

Rubber seals on both sides
Greater radial internal clearance
FAG 3004 2RS C3 bearing with precisely stated execution.

45x75x20 mm

Single-row tapered roller bearing 32009 AX ZKL for high radial load combined with axial load in one direction. Its separable design allows the inner ring with rollers and the outer ring to be mounted independently.

50x90x21.75 mm

Single-row tapered roller bearing 30210 A P6X ZVL for high radial loads and axial load in one direction. The P6X tolerance version is intended for arrangements with higher accuracy requirements; the complete A P6X designation must match when replacing the bearing.