Bearing - T7FC 055 QS1CL7CVE141 SKF

40x90x34 mm

Double-row angular contact ball bearing 3308 D DKF for combined radial and axial loads in both directions. Its rigid, non-separable design provides accurate shaft guidance and can also accommodate tilting moments.

40x80x23 mm

Single-row cylindrical roller bearing NU 2208 E DPI for high radial loads. The NU design allows axial displacement of the shaft relative to the housing in both directions; E denotes an increased-capacity internal design.

70x95x18 mm

Single-direction thrust ball bearing 51114 FAG for carrying axial load in one direction. Its separable open design simplifies installation of the shaft washer, housing washer and ball-and-cage assembly; the bearing is not suitable for radial load.

55x72x9 mm

Thin-section single-row deep groove ball bearing 61811 2RZ SKF with low-friction seals on both sides. It combines a compact radial section with low friction and carries radial loads plus axial loads in both directions.

12x37x12 mm

6301 2RSH SKF deep groove ball bearing has contact rubber seals on both sides, helping retain lubricant and protect the raceways against contamination and moisture.

50x90x21.75 mm

Single-row tapered roller bearing 30210 A P6X ZVL for high radial loads and axial load in one direction. The P6X tolerance version is intended for arrangements with higher accuracy requirements; the complete A P6X designation must match when replacing the bearing.

35x72x17 mm

1207 P6 ZKL double-row self-aligning ball bearing with a cylindrical bore accommodates slight shaft-to-housing misalignment. P6 accuracy provides tighter dimensional and running tolerances than the normal class.

25x52x15 mm

High-precision spindle ball bearing S 6205 C 18 TA UP GMN for precision arrangements carrying combined radial load and axial load in one direction. The complete C 18 TA UP design, pairing and required preload must be preserved when replacing it.

35x72x23 mm

NJ 2207 ZKL single-row cylindrical roller bearing is designed for high radial loads and can also locate the shaft axially in one direction. Its separable construction allows the inner ring to be installed independently of the outer ring and roller assembly.

40x48x20 mm

Full-complement drawn-cup needle roller bearing DL 4020 NADELLA with open ends and without an inner ring. It provides high radial load capacity within a very small radial section.