Bearing - 22212 CCK SKF

25x33x20 mm

NK 25/20 INA needle roller bearing without an inner ring provides high radial load capacity within a very small cross-section. The needles run directly on a suitably hardened and ground 25 mm shaft raceway.

65x120x32.75 mm

Single-row tapered roller bearing 32213 ZKL for high radial loads and axial load in one direction. The separable outer ring simplifies installation; the correct clearance or preload is set in conjunction with an opposing bearing.

15x28x9 mm

Single-direction thrust ball bearing 51102 URB for carrying axial load in one direction. Its separable design simplifies installation of the individual washers and ball-and-cage assembly; when replacing, compare the complete designation, dimensions and load direction.

25x62x17 mm

Single-row cylindrical roller bearing N 305 ZKL for high radial loads and accurate shaft guidance. The N design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.

60x110x22 mm
Higher accuracy class P6

Single-row angular-contact ball bearing 7212 P6 ZKL for combined radial load and axial load in one direction. P6 accuracy is suitable for arrangements with higher requirements for dimensional and running accuracy.

30x55x13 mm

Single-row deep groove ball bearing 6006 2Z FAG with non-contact metal shields on both sides. Low-friction design for radial and axial loads in both directions; compare the complete 2Z marking before replacement.

50x110x27 mm

1310 ZKL double-row self-aligning ball bearing with a cylindrical bore can accommodate slight misalignment between the shaft and housing. The open design is suitable for radial loads and limited axial loads in both directions.

35x80x21 mm

6307 Z ZKL deep groove ball bearing has a non-contact metal shield on one side. The shield limits the ingress of larger contaminants and lubricant loss while retaining low friction; the opposite side remains open.

35x72x17 mm

Double-row self-aligning ball bearing 1207 K ZKL with a 1:12 tapered bore. It accommodates slight misalignment and shaft deflection while carrying radial loads and light axial loads in both directions.