Bearing - 22224 E C3 SKF

60x150x35 mm

Single-row deep-groove ball bearing 6412 N ZKL for radial and axial loads in both directions. The N design has a snap-ring groove in the outer ring; when replacing, retain the complete designation and verify the axial locating method.

51105 ZKL single-direction thrust ball bearing is a separable bearing for axial load in one direction. It consists of a shaft washer, housing washer and ball-and-cage assembly and is not designed to carry radial load.

30x55x13 mm

Single-row deep groove ball bearing 6006 2Z FAG with non-contact metal shields on both sides. Low-friction design for radial and axial loads in both directions; compare the complete 2Z marking before replacement.

35x100x25 mm

Single-row cylindrical roller bearing NJ 407 ZKL for high radial loads with axial shaft location in one direction. The NJ design permits axial displacement in the opposite direction; when replacing, compare the complete designation and required internal clearance.

17x47x14 mm

Single-row deep groove ball bearing 6303 Z SRO with a non-contact metal shield on one side. A versatile design for radial loads and light axial loads in both directions, offering low friction and good speed capability.

75x130x25 mm

Single-row cylindrical roller bearing NU 215 ZKL for high radial loads and accurate shaft guidance. The NU design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.

Needle roller bearing HK 2012 CX is a thin-walled bearing with a drawn outer cup, cage and needle rollers. Its open-ended design without an inner ring provides high radial load capacity within a very small radial space.

The raceway is normally formed by a hardened and ground shaft surface; when the shaft cannot meet the raceway requirements, a suitable separate inner ring must be used.

SS 6203 2RS neu stainless-steel deep-groove ball bearing is a single-row bearing with rubber seals on both sides. The stainless execution improves resistance to moisture and corrosion, while the seals protect the factory grease and bearing interior.

45x75x20 mm

Single-row tapered roller bearing 32009 AX ZKL for high radial load combined with axial load in one direction. Its separable design allows the inner ring with rollers and the outer ring to be mounted independently.

40x80x18 mm
Metal shields on both sides

Single-row deep-groove ball bearing 6208 2Z ROLLWAY for radial load and moderate axial loads in both directions. Non-contact metal shields retain grease with low friction and protect against ordinary dry contamination.

17x40x12 mm
Metal shields on both sides
Greater radial internal clearance

Single-row deep groove ball bearing 6203 2Z C3 SKF with non-contact steel shields on both sides and C3 radial internal clearance. Suitable for high-speed applications and arrangements where fits, temperature or load reduce the bearing's operating clearance.