Bearing - 242190X 242282XGE0 GAMET

62209 2RS KINEX deep-groove ball bearing is a single-row bearing with rubber seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage and common contaminants.

7204 AA ZKL single-row angular-contact ball bearing is designed for combined radial and axial loads. Under the ZKL designation system, the AA execution has a 26° contact angle and carries axial load in one direction.

61903 2RS1 SKF deep-groove ball bearing is a single-row bearing with contact rubber seals on both sides. It carries radial loads and moderate axial loads in both directions, while the factory grease is protected against leakage and common contaminants.

Deep groove ball bearing 61803 2RS IBB in a slim design with rubber seals on both sides. Suitable for compact arrangements where protection against dust and contamination is important.

45x100x25 mm

6309 2RS1 SKF deep-groove ball bearing is a single-row radial bearing with contact seals on both sides. It carries radial loads and moderate axial forces in either direction. The 2RS1 design protects the internal rolling contact from contaminants and helps retain lubricant inside the bearing.

55x63x25 mm

The HK 5525 ZEN drawn-cup needle roller bearing is a thin-walled, open-ended bearing without an inner ring. It provides high radial load capacity where radial installation space is very limited.

The shaft acts directly as the inner raceway and therefore requires suitable hardness, accuracy and surface finish. This bearing does not provide axial location.

55x90x23 mm

The 32011 FBJ single-row tapered roller bearing is a separable bearing for combined radial and axial loads. Tapered raceways and rollers provide high rigidity and load-carrying capacity.

One bearing supports axial load in one direction; an opposed pair is used for axial location in both directions. The open design requires suitable lubrication.

6313 MP63 ZKL deep-groove ball bearing is an open single-row bearing with a solid brass or bronze cage (M), P6 accuracy and greater-than-normal C3 radial clearance (P63). It carries radial loads and axial loads in both directions.

Insert bearing UC 204 ZKL is designed for matching bearing housings and units. Its extended inner ring is secured to the shaft by two set screws, enabling quick mounting.

The spherical outside surface facilitates alignment in the housing seat, while seals on both sides help protect the bearing interior from common contaminants.

50x90x20 mm

The 6210 N KINEX deep-groove ball bearing is a single-row radial bearing with a snap-ring groove in the outer ring. The groove simplifies axial location in the housing, while the deep raceways support radial loads and moderate axial forces in both directions.

This open, unsealed design is suitable for gearboxes, electric motors and industrial positions with a separate lubrication system.

SS 6203 2RS neu stainless-steel deep-groove ball bearing is a single-row bearing with rubber seals on both sides. The stainless execution improves resistance to moisture and corrosion, while the seals protect the factory grease and bearing interior.

NA 4906 V DKF needle roller bearing is a full-complement radial bearing with machined outer and inner rings. The high number of needles provides high radial load capacity in a small radial cross-section; the design is intended for carefully lubricated arrangements at moderate speeds.