Bearing - 3202 ATN9 SKF

SS 6203 2RS neu stainless-steel deep-groove ball bearing is a single-row bearing with rubber seals on both sides. The stainless execution improves resistance to moisture and corrosion, while the seals protect the factory grease and bearing interior.

Self-aligning ball bearing 2306 E 2RS1TN9 SKF has two rows of balls and a common spherical raceway in the outer ring. This design accommodates static and dynamic misalignment between the shaft and housing.

Seals on both sides help protect the bearing interior from contaminants. It is suitable for arrangements where shaft deflection or mounting misalignment can occur.

45x85x30 mm

Double-row angular contact ball bearing 3209 ZKL for combined radial loads and axial loads in both directions. A robust solution for arrangements requiring good rigidity and accurate shaft guidance.

Cylindrical roller bearing NU 306 ZKL is a single-row radial bearing with high load capacity. The NU design has two integral flanges on the outer ring and an inner ring without flanges.

It permits axial displacement of the shaft relative to the housing in both directions and is therefore primarily used as a non-locating bearing. It does not provide axial shaft location.

30x72x19 mm

Single-row cylindrical roller bearing NJ 306 FRB for high radial loads and axial location in one direction. The NJ design permits axial displacement of the shaft relative to the housing in the opposite direction; when replacing, compare the complete designation and required internal clearance.

40x80x18 mm
Metal shields on both sides

Single-row deep-groove ball bearing 6208 2Z ROLLWAY for radial load and moderate axial loads in both directions. Non-contact metal shields retain grease with low friction and protect against ordinary dry contamination.

6305 2ZC3 SKF deep-groove ball bearing is a single-row bearing with steel shields on both sides and C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and is suitable for higher-speed operation.

14x22x20 mm

Needle roller bearing without inner ring NK 14/20-XL INA for high radial loads in a compact space. The 14 mm dimension is the under-roller diameter, not a conventional bore; a suitably prepared shaft surface forms the inner raceway.

60x110x22 mm
Higher accuracy class P6

Single-row angular-contact ball bearing 7212 P6 ZKL for combined radial load and axial load in one direction. P6 accuracy is suitable for arrangements with higher requirements for dimensional and running accuracy.

Needle roller bearing HK 2012 CX is a thin-walled bearing with a drawn outer cup, cage and needle rollers. Its open-ended design without an inner ring provides high radial load capacity within a very small radial space.

The raceway is normally formed by a hardened and ground shaft surface; when the shaft cannot meet the raceway requirements, a suitable separate inner ring must be used.