Bearing - 6206 2RZ SKF

40x90x34 mm

Double-row angular contact ball bearing 3308 D DKF for combined radial and axial loads in both directions. Its rigid, non-separable design provides accurate shaft guidance and can also accommodate tilting moments.

40x80x18 mm
Metal shields on both sides

Single-row deep-groove ball bearing 6208 2Z ROLLWAY for radial load and moderate axial loads in both directions. Non-contact metal shields retain grease with low friction and protect against ordinary dry contamination.

50x90x21.75 mm

Single-row tapered roller bearing 30210 A P6X ZVL for high radial loads and axial load in one direction. The P6X tolerance version is intended for arrangements with higher accuracy requirements; the complete A P6X designation must match when replacing the bearing.

50x80x20 mm

Single-row tapered roller bearing 32010 X FAG with a separable design for high combined radial and one-direction axial loads. Compare the exact X variant with the original part; this product designation does not include XL.

55x90x22 mm

51211 ZKL single-direction thrust ball bearing is designed to carry axial load in one direction. Its separable construction consists of a shaft washer, a housing washer and a ball-and-cage assembly.

15x28x9 mm

Single-direction thrust ball bearing 51102 URB for carrying axial load in one direction. Its separable design simplifies installation of the individual washers and ball-and-cage assembly; when replacing, compare the complete designation, dimensions and load direction.

40x48x20 mm

Full-complement drawn-cup needle roller bearing DL 4020 NADELLA with open ends and without an inner ring. It provides high radial load capacity within a very small radial section.

25x62x17 mm

1305 HARP double-row self-aligning ball bearing with a cylindrical bore can accommodate slight misalignment between the shaft and housing. The open design is suitable for radial loads and limited axial loads in both directions.