Bearing - 6211 K C2 SKF

55x90x23 mm

The 32011 FBJ single-row tapered roller bearing is a separable bearing for combined radial and axial loads. Tapered raceways and rollers provide high rigidity and load-carrying capacity.

One bearing supports axial load in one direction; an opposed pair is used for axial location in both directions. The open design requires suitable lubrication.

6208 2Z C3 SKF deep-groove ball bearing is a single-row bearing with steel shields on both sides and C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and is suitable for higher-speed operation.

6305 2ZC3 SKF deep-groove ball bearing is a single-row bearing with steel shields on both sides and C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and is suitable for higher-speed operation.

17x47x15.25 mm

30303 MGK tapered roller bearing is a single-row, separable bearing for combined radial and axial loads. Its tapered raceways carry axial load in one direction; bearings are normally paired where axial load must be supported in both directions.

50x110x27 mm

The 6310 C 2HRS C3 FAG deep-groove ball bearing is a Generation C single-row bearing with contact seals on both sides and C3 radial internal clearance. It is grease-filled and normally requires no relubrication under suitable operating conditions.

Suitable for motors, pumps, fans, gearboxes and industrial drives requiring contamination protection and additional internal clearance for temperature or tight fits.

55x63x25 mm

The HK 5525 ZEN drawn-cup needle roller bearing is a thin-walled, open-ended bearing without an inner ring. It provides high radial load capacity where radial installation space is very limited.

The shaft acts directly as the inner raceway and therefore requires suitable hardness, accuracy and surface finish. This bearing does not provide axial location.

Self-aligning ball bearing 2306 E 2RS1TN9 SKF has two rows of balls and a common spherical raceway in the outer ring. This design accommodates static and dynamic misalignment between the shaft and housing.

Seals on both sides help protect the bearing interior from contaminants. It is suitable for arrangements where shaft deflection or mounting misalignment can occur.

6000 2RS1 SKF deep-groove ball bearing is a single-row bearing with rubber seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage and common contaminants.

50x90x20 mm

The 6210 N KINEX deep-groove ball bearing is a single-row radial bearing with a snap-ring groove in the outer ring. The groove simplifies axial location in the housing, while the deep raceways support radial loads and moderate axial forces in both directions.

This open, unsealed design is suitable for gearboxes, electric motors and industrial positions with a separate lubrication system.

63/22 2RS KOYO deep-groove ball bearing is a single-row bearing with contact rubber seals on both sides. It carries radial loads and moderate axial loads in both directions, while the factory grease is protected against leakage and common contaminants.