Bearing - 6312 SKF

6022 2Z C3 FAG deep-groove ball bearing is a single-row bearing with steel shields on both sides and C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and is suitable for higher-speed operation.

25x42x9 mm

The 61905 2RS KINEX thin-section deep-groove ball bearing is a compact single-row bearing with contact rubber seals on both sides. It combines a small radial cross-section and low weight with the ability to support radial loads and moderate axial forces in both directions.

Suitable for small electric motors, instruments, gearboxes, robotics and other mechanisms with restricted radial space.

NU 2205 URB single-row cylindrical roller bearing is a separable bearing for high radial loads. The NU design has two integral flanges on the outer ring and a flangeless inner ring, allowing axial displacement of the shaft relative to the housing in both directions.

30x62x20 mm

Rubber seals on both sides

The 62206 2RS1 SKF deep-groove ball bearing is a single-row bearing with contact seals on both sides. Its 30 × 62 × 20 mm dimensions, factory grease fill and effective lubricant retention make it suitable for compact, protected bearing arrangements.

100x215x73 mm

Spherical roller bearing 22320 KM ZKL with a tapered bore and machined brass cage for high radial loads and axial loads in both directions. Its self-aligning design helps accommodate misalignment and shaft deflection.

31305 A KINEX tapered roller bearing is a separable single-row bearing for high radial loads combined with axial load in one direction. Two bearings in an opposed arrangement are normally used when axial location is required in both directions.

Deep groove ball bearing 6006 2Z C3 ZVL is a single-row bearing with metal shields on both sides and C3 radial internal clearance. It accommodates radial loads and moderate axial loads in both directions.

The non-contact 2Z shields limit contaminant ingress while maintaining low friction. C3 clearance is greater than Normal and must suit the temperature, speed and fit; it is not an automatic substitute for standard clearance.

Cylindrical roller bearing NU 2210 ZKL is a single-row radial bearing with high load capacity. The NU design has two integral flanges on the outer ring and an inner ring without flanges.

It permits axial displacement of the shaft relative to the housing in both directions and is therefore primarily used as a non-locating bearing. It does not provide axial shaft location.

50x90x20 mm

The 6210 N KINEX deep-groove ball bearing is a single-row radial bearing with a snap-ring groove in the outer ring. The groove simplifies axial location in the housing, while the deep raceways support radial loads and moderate axial forces in both directions.

This open, unsealed design is suitable for gearboxes, electric motors and industrial positions with a separate lubrication system.