Bearing - 7014 TBP4 ZKL

Bearing - 6003 Z ZKL

17 × 35 × 10 mm. single-row deep-groove ball bearing with a non-contact metal shield on one side. The shield limits coarse contamination while retaining low friction and good high-speed capability.

Bearing - 623 ZKL

3 × 10 × 4 mm. single-row deep groove ball bearing in open design. A compact bearing for radial and moderate axial loads in both directions, intended for arrangements providing their own lubrication and protection.

Bearing - 3206 ZKL

30 × 62 × 23 mm. double-row angular contact ball bearing for combined radial and axial loads in both directions. Its compact design provides rigid and accurate shaft guidance.

Bearing - 6201 ZKL

12 × 32 × 10 mm. single-row deep groove ball bearing in open design. A compact bearing for radial and moderate axial loads in both directions, intended for arrangements providing their own lubrication and protection.

Bearing - 6307 2RS1 SKF

35 × 80 × 21 mm. bearing for replacement use. Before ordering, compare the complete designation and verify the dimensions, design and fit with the original part. Confirm compatibility against SKF documentation and the requirements of the specific application.

Bearing - 609 2Z ZKL

9 × 24 × 7 mm. single-row deep groove ball bearing with non-contact metal shields on both sides. Suitable for radial and moderate axial loads in both directions, combining low friction with protection of the lubricant from larger contaminants.

Bearing - 6004 2RS ZVL

20 × 42 × 12 mm. Single-row deep-groove ball bearing with rubber seals on both sides. Check the complete designation and suitability for the specific application.

Bearing - 6306 Z ZKL

30 × 72 × 19 mm. Single-row deep groove ball bearing with a non-contact metal shield on one side. It carries radial and limited axial loads in both directions; the opposite side remains open.

Bearing - 626 2Z FAG

6 × 19 × 6 mm. is a single-row deep-groove ball bearing with two non-contact metal shields. Its versatile design supports radial load and moderate axial loads in both directions, while low friction makes it suitable for higher speeds. The shields help retain lubricant and limit the entry of larger contaminants. This is a general-purpose machine bearing, not a contact-sealed or watertight design.