Bearing - 7212 ACD P4A SKF

35x80x21 mm

NJ 307 URB single-row cylindrical roller bearing is designed for high radial loads and can also locate the shaft axially in one direction. Its separable construction allows the inner ring to be installed independently of the outer ring and roller assembly.

Deep groove ball bearing SS 6001 2RS CRB is a compact single-row 6001-series bearing with rubber seals on both sides. It is suitable for shaft arrangements carrying radial and moderate axial loads.

The double-sealed design helps protect the bearing interior from common contaminants. Before ordering, compare the complete designation, dimensions and operating requirements; the SS prefix is part of this specific variant designation.

25x52x18 mm

2205 E 2RS1TN9 SKF double-row self-aligning ball bearing with a cylindrical bore accommodates slight misalignment and shaft deflection. Contact seals on both sides (2RS1) protect the internal components and help retain lubricant.

Deep groove ball bearing 6012 SKF is a single-row bearing in an open design. It accommodates radial loads and moderate axial loads in both directions and is suitable for accurate shaft support.

The open construction has no integral shields or seals, allowing direct lubricant access but requiring a clean or externally protected environment and a correctly designed lubrication system.

12x28x11 mm

Single-direction thrust ball bearing 51201 URB for carrying axial load in one direction. Its separable design simplifies installation of the individual washers and ball-and-cage assembly; when replacing, compare the complete designation, dimensions and load direction.

75x130x25 mm

Single-row cylindrical roller bearing NU 215 ZKL for high radial loads and accurate shaft guidance. The NU design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.

Deep groove ball bearing 61803 2RS IBB in a slim design with rubber seals on both sides. Suitable for compact arrangements where protection against dust and contamination is important.

35x100x25 mm

Single-row cylindrical roller bearing NJ 407 ZKL for high radial loads with axial shaft location in one direction. The NJ design permits axial displacement in the opposite direction; when replacing, compare the complete designation and required internal clearance.

35x72x23 mm

Double-row self-aligning ball bearing 2207 ZKL with a cylindrical bore. The spherical outer-ring raceway accommodates angular misalignment; suitable primarily for radial load and limited axial load in both directions.