Bearing - BAH0013 D SKF

Bearing - 32210 A TPS

Ložisko TPS s úplným označením. Before ordering, compare the full designation and execution with the part used in your equipment.

Bearing - 6004 2RS ZVL

20 × 42 × 12 mm. Single-row deep-groove ball bearing with rubber seals on both sides. Check the complete designation and suitability for the specific application.

Bearing - 6001 2RS ZVL

12 × 28 × 8 mm. Single-row deep-groove ball bearing with contact rubber seals on both sides (2RS). Check the complete designation and application suitability.

Bearing - 6307 2RS ZVL

Bearing.

Bearing - 32308 JR DPI

40 × 90 × 35.25 mm. bearing. Verify the complete designation and dimensions in manufacturer documentation before selection.

Bearing - PLC 65 4 ZKL

bearing for accurate replacement by the complete original-part designation.

Bearing - GE 12 E BBC

12 × 22 × 10 mm. The radial spherical plain bearing is a compact sliding bearing with spherical sliding surfaces. It accommodates tilting, slow oscillating movement and misalignment under radial and combined loads. This open, unsealed design is suitable for linkages, small hydraulic mechanisms and machine joints with regular lubrication and external contamination protection.

Bearing - 628 NACHI

8 × 24 × 8 mm. Open single-row 628 deep-groove ball bearing for accurate support of small shafts and rotating mechanisms. It carries radial load and limited axial load in both directions.

Bearing - 6203 2RS KINEX

17 × 40 × 12 mm. single-row deep groove ball bearing with contact rubber seals on both sides. A compact solution for radial and moderate axial loads in both directions, protected against dust, contamination and lubricant loss.

Bearing - 6302 2RS KINEX

15 × 42 × 13 mm. KINEX bearing for industrial applications. When replacing a part, always verify the complete designation, dimensions, design and application requirements against the manufacturer documentation.

Bearing - SD 52 DIN 472 NEREZ NEU

Bearing.

Bearing - 6200 2Z DPI

10 × 30 × 9 mm. is a single-row deep-groove ball bearing with two non-contact metal shields. It supports radial load and moderate axial loads in both directions, while its low-friction design makes it suitable for higher speeds. The shields help retain lubricant and limit the entry of larger contaminants. This is a general-purpose machine bearing, not a contact-sealed or watertight design.