Bearing - NU 216 ECML C3H SKF

35x80x21 mm

6307 Z ZKL deep groove ball bearing has a non-contact metal shield on one side. The shield limits the ingress of larger contaminants and lubricant loss while retaining low friction; the opposite side remains open.

Rubber seals on both sides
Greater radial internal clearance
FAG 3004 2RS C3 bearing with precisely stated execution.

12x28x11 mm

Single-direction thrust ball bearing 51201 URB for carrying axial load in one direction. Its separable design simplifies installation of the individual washers and ball-and-cage assembly; when replacing, compare the complete designation, dimensions and load direction.

75x130x25 mm

Single-row cylindrical roller bearing NU 215 ZKL for high radial loads and accurate shaft guidance. The NU design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.

40x68x19 mm

Single-row tapered roller bearing 32008 JR DPI for high radial loads combined with axial load in one direction. Its separable design simplifies mounting and allows running clearance or preload to be set in a paired arrangement.

25x62x17 mm

1305 HARP double-row self-aligning ball bearing with a cylindrical bore can accommodate slight misalignment between the shaft and housing. The open design is suitable for radial loads and limited axial loads in both directions.

40x80x18 mm
Metal shields on both sides

Single-row deep-groove ball bearing 6208 2Z ROLLWAY for radial load and moderate axial loads in both directions. Non-contact metal shields retain grease with low friction and protect against ordinary dry contamination.

20x47x14 mm
Higher accuracy class P4

High-precision spindle ball bearing S 6204 C TA P4 GMN for precision arrangements carrying combined radial load and axial load in one direction. The complete C TA P4 design, pairing and required preload must be preserved when replacing it.

35x72x17 mm

Single-row deep-groove ball bearing 6207 N ZKL for radial and axial loads in both directions. The N design has a snap-ring groove in the outer ring; when replacing, retain the complete designation and verify the axial locating method.