Bearing - NU 306 ZKL

YAR 207 2F SKF insert bearing has an inner ring extended on both sides and locks onto the shaft with two set screws. A spherical outside surface, contact seals with flingers on both sides and relubrication capability support easy installation and reliable operation.

61903 2RS1 SKF deep-groove ball bearing is a single-row bearing with contact rubber seals on both sides. It carries radial loads and moderate axial loads in both directions, while the factory grease is protected against leakage and common contaminants.

6208 2Z C3 SKF deep-groove ball bearing is a single-row bearing with steel shields on both sides and C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and is suitable for higher-speed operation.

629 2RS KINEX deep-groove ball bearing is a single-row bearing with rubber seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage and common contaminants.

50x90x20 mm

The 6210 N KINEX deep-groove ball bearing is a single-row radial bearing with a snap-ring groove in the outer ring. The groove simplifies axial location in the housing, while the deep raceways support radial loads and moderate axial forces in both directions.

This open, unsealed design is suitable for gearboxes, electric motors and industrial positions with a separate lubrication system.

110x170x38 mm

The 32022 X SKF single-row tapered roller bearing is a separable bearing for high radial loads combined with axial load in one direction. The cone assembly can be mounted separately from the outer ring, simplifying installation and maintenance.

This open, unsealed design requires suitable lubrication. Opposed bearing arrangements are normally used when axial loads must be supported in both directions.

6305 2ZC3 SKF deep-groove ball bearing is a single-row bearing with steel shields on both sides and C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and is suitable for higher-speed operation.

6016 2ZRC3 ZVL deep-groove ball bearing is a thin-section single-row bearing with non-contact metal shields on both sides (2ZR) and greater-than-normal C3 radial clearance. It combines low friction, high-speed capability and protection of the factory lubricant against common dust.

31305 A KINEX tapered roller bearing is a separable single-row bearing for high radial loads combined with axial load in one direction. Two bearings in an opposed arrangement are normally used when axial location is required in both directions.

HK 3520 CX drawn-cup needle roller bearing is an open-ended, thin-walled bearing without an inner ring. It provides high radial load capacity in a very small radial space; a suitably hardened and precision-ground shaft forms the inner raceway.

S 6001 2RS neu deep-groove ball bearing is a single-row bearing with contact rubber seals on both sides. It carries radial loads and moderate axial loads in both directions, while the factory grease is protected against leakage and common contaminants.