Bearing - T7FC 065 S1QCL7CVE141 SKF

40x68x19 mm

Single-row tapered roller bearing 32008 JR DPI for high radial loads combined with axial load in one direction. Its separable design simplifies mounting and allows running clearance or preload to be set in a paired arrangement.

25x62x17 mm

1305 HARP double-row self-aligning ball bearing with a cylindrical bore can accommodate slight misalignment between the shaft and housing. The open design is suitable for radial loads and limited axial loads in both directions.

25x52x18 mm

2205 E 2RS1TN9 SKF double-row self-aligning ball bearing with a cylindrical bore accommodates slight misalignment and shaft deflection. Contact seals on both sides (2RS1) protect the internal components and help retain lubricant.

40x80x18 mm

6208 2RSR KINEX deep groove ball bearing has contact rubber seals on both sides, helping retain lubricant and protect the raceways against contamination and moisture.

75x130x25 mm

Single-row cylindrical roller bearing NU 215 ZKL for high radial loads and accurate shaft guidance. The NU design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.

65x120x32.75 mm

Single-row tapered roller bearing 32213 ZKL for high radial loads and axial load in one direction. The separable outer ring simplifies installation; the correct clearance or preload is set in conjunction with an opposing bearing.

40x62x22 mm

Single-row cylindrical roller bearing NU 4908 DKF for high radial loads and free axial displacement of the shaft relative to the housing in both directions. The NU design has two guiding flanges on the outer ring and a flange-free inner ring.

50x90x21.75 mm

Single-row tapered roller bearing 30210 A P6X ZVL for high radial loads and axial load in one direction. The P6X tolerance version is intended for arrangements with higher accuracy requirements; the complete A P6X designation must match when replacing the bearing.

40x48x20 mm

Full-complement drawn-cup needle roller bearing DL 4020 NADELLA with open ends and without an inner ring. It provides high radial load capacity within a very small radial section.

30x62x20 mm

NU 2206 BNA P62 ZKL single-row cylindrical roller bearing is designed for high radial loads and allows axial displacement of the shaft relative to the housing in both directions. P62 denotes P6 dimensional and running accuracy combined with reduced C2 radial internal clearance.

35x72x17 mm

Double-row self-aligning ball bearing 1207 K ZKL with a 1:12 tapered bore. It accommodates slight misalignment and shaft deflection while carrying radial loads and light axial loads in both directions.