Bearings, Page 2
Product sorting
List of products
35x72x17 mm
6207 2Z ZKL deep-groove ball bearing is a single-row radial bearing with non-contact metal shields on both sides. It supports radial loading and moderate axial forces in either direction. The 2Z shields help retain lubricant and keep out coarse contaminants while maintaining low friction and suitability for higher speeds.
15x42x17 mm
2302 2RS ZVL self-aligning ball bearing is a double-row bearing with a spherical outer-ring raceway and rubber seals on both sides. It accommodates moderate shaft-to-housing misalignment while carrying radial loads and light axial forces in either direction.
17x40x17 mm
The 3203 2RS neu double-row angular contact ball bearing supports radial loads, axial forces in both directions and tilting moments. Contact rubber seals on both sides help retain grease and protect the raceways from common contaminants.
A compact solution for gearboxes, pumps, hubs, agricultural machinery and other positions requiring increased axial rigidity.
2302 2RS CODEX self-aligning ball bearing has two rows of balls and a spherical raceway in the outer ring, allowing it to compensate for angular misalignment between the shaft and housing. Rubber seals on both sides protect the factory grease and the bearing interior against common contaminants.
6305 2ZC3 SKF deep-groove ball bearing is a single-row bearing with steel shields on both sides and C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and is suitable for higher-speed operation.
NA 4906 V DKF needle roller bearing is a full-complement radial bearing with machined outer and inner rings. The high number of needles provides high radial load capacity in a small radial cross-section; the design is intended for carefully lubricated arrangements at moderate speeds.
25x62x17 mm
Single-row cylindrical roller bearing N 305 ZKL for high radial loads and accurate shaft guidance. The N design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.
35x72x17 mm
Single-row cylindrical roller bearing N 207 ZKL for high radial loads and accurate shaft guidance. The N design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.
35x72x17 mm
Single-row deep-groove ball bearing 6207 N ZKL for radial and axial loads in both directions. The N design has a snap-ring groove in the outer ring; when replacing, retain the complete designation and verify the axial locating method.
35x72x17 mm
Double-row self-aligning ball bearing 1207 K ZKL with a 1:12 tapered bore. It accommodates slight misalignment and shaft deflection while carrying radial loads and light axial loads in both directions.
35x72x17 mm
6207 RS ZKL single-row deep groove ball bearing with a contact rubber seal on one side. Suitable for radial and moderate axial loads in both directions when one side requires improved protection from dust, contamination and lubricant loss.
25x62x17 mm
1305 HARP double-row self-aligning ball bearing with a cylindrical bore can accommodate slight misalignment between the shaft and housing. The open design is suitable for radial loads and limited axial loads in both directions.
35x72x17 mm
1207 P6 ZKL double-row self-aligning ball bearing with a cylindrical bore accommodates slight shaft-to-housing misalignment. P6 accuracy provides tighter dimensional and running tolerances than the normal class.
35x60x17 mm
ZKL 51207 thrust ball bearing is designed to carry axial load in one direction. It is used where force acting along the shaft axis must be reliably supported.
