15 × 24 × 5 mm. thin-section ball bearing is an exceptionally compact single-row bearing for a 15 mm shaft. Rubber 2RS seals on both sides protect the rolling contact and retain lubricant. Its low cross-section and 5 mm width suit precision mechanisms with limited space and moderate loading.
40 × 80 × 18 mm. Single-row deep groove ball bearing in open design, with a snap-ring groove in the outer ring. Suitable for radial and axial loads in both directions; the N suffix denotes the groove, not an included snap ring.
30 × 55 × 13 mm. Single-row deep groove ball bearing with non-contact metal shields on both sides. Low-friction design for radial and axial loads in both directions; compare the complete 2Z marking before replacement.
17 × 47 × 14 mm. Single-row deep groove ball bearing with a non-contact metal shield on one side. A versatile design for radial loads and light axial loads in both directions, offering low friction and good speed capability.
55 × 72 × 9 mm. Thin-section single-row deep groove ball bearing 61811 2RZ SKF with low-friction seals on both sides. It combines a compact radial section with low friction and carries radial loads plus axial loads in both directions.
12 × 37 × 12 mm. single-row deep groove ball bearing with a non-contact metal shield on one side. Suitable for radial and moderate axial loads in both directions when one side of the bearing needs protection from coarse contamination.
35 × 72 × 17 mm. single-row deep groove ball bearing with a contact rubber seal on one side. Suitable for radial and moderate axial loads in both directions when one side requires improved protection from dust, contamination and lubricant loss.
12 × 32 × 10 mm. single-row deep groove ball bearing in an open design is a versatile choice for radial loads and moderate axial loads in both directions. It offers low friction and smooth running.
35 × 80 × 21 mm. single-row deep groove ball bearing with contact rubber seals on both sides. A dependable choice for radial and bidirectional axial loads where retaining lubricant and protecting the bearing interior from contamination are important.
10 × 26 × 8 mm. deep groove ball bearing has contact rubber seals on both sides and greater-than-normal C3 radial internal clearance. The seals protect lubricant and raceways, while C3 provides allowance for clearance reduction caused by fits or operating temperature.
40 × 80 × 18 mm. deep groove ball bearing has contact rubber seals on both sides, helping retain lubricant and protect the raceways against contamination and moisture.
