Ball bearings, Page 299

Bearing - 6209 Z ZKL

45 × 85 × 19 mm. Metal shield on one side.

Bearing - 6209 TB P6 ZKL

45 × 85 × 19 mm. Higher accuracy class P6.

Bearing - 6203 C 2Z FAG

17 × 40 × 12 mm. Metal shields on both sides.

Bearing - 61819 Y INA

95 × 120 × 13 mm. No seal; Y pressed brass cage.

Bearing - 61815 Y INA

75 × 95 × 10 mm. No seal; Y pressed brass cage.

Bearing - 6011 GPZ

55 × 90 × 18 mm. Single-row deep-groove ball bearing for size 55 × 90 × 18 mm. Bore diameter d = 55 mm, outside diameter D = 90 mm, width B = 18 mm.

Bearing - 6008 2RS1 C3 SKF

40 × 68 × 15 mm. Rubber seals on both sides. Greater radial internal clearance.

Bearing - 6005 EU-ROLL

25 × 47 × 12 mm. Technické provedení a kompatibilitu ověřte podle úplného označení výrobce a požadavků aplikace.

Bearing - 6004 FAG

20 × 42 × 12 mm. Technické provedení a kompatibilitu ověřte podle úplného označení výrobce a požadavků aplikace.

Bearing - 6002 C 2Z FAG

15 × 32 × 9 mm. Metal shields on both sides.

Bearing - 53210 FAG

50 × 78 × 26 mm. Technické provedení a kompatibilitu ověřte podle úplného označení výrobce a požadavků aplikace.

Bearing - 51108 P6 URB

40 × 60 × 13 mm. thrust ball bearing is designed to carry axial load in one direction. It is used where force acting along the shaft axis must be reliably supported.

Bearing - 51106 ZKL

30 × 47 × 11 mm. thrust ball bearing is designed to carry axial load in one direction. It is used where force acting along the shaft axis must be reliably supported.

Bearing - 4200 BB TVH FAG

10 × 30 × 14 mm. Technické provedení a kompatibilitu ověřte podle úplného označení výrobce a požadavků aplikace.

Bearing - 3203 C3 ZKL

17 × 40 × 17 mm. Greater radial internal clearance.

Bearing - 2212 ZKL

60 × 110 × 28 mm. ZKL bearing for industrial applications. When replacing a part, always verify the complete designation, dimensions, design and application requirements against the manufacturer documentation.

Bearing - 1311 EKTN9 SKF

55 × 120 × 29 mm. SKF bearing for industrial applications. When replacing a part, always verify the complete designation, dimensions, design and application requirements against the manufacturer documentation.