Bearings 10 × 26 × 8 mm

Bearing - 6000 2RS ZVL

10 × 26 × 8 mm. single-row deep groove ball bearing with contact rubber seals on both sides. A compact solution for radial and moderate axial loads in both directions, protected against dust, contamination and lubricant loss.

Bearing - 6000 FLT

10 × 26 × 8 mm. Single-row deep-groove ball bearing in open design without covers or seals specified in the designation. Check the complete designation and application suitability.

Bearing - 6000 2RSH SKF

10 × 26 × 8 mm. single-row deep groove ball bearing with contact rubber seals on both sides. A compact solution for radial and moderate axial loads in both directions, protected against dust, contamination and lubricant loss.

Bearing - 6000 RS ZKL

10 × 26 × 8 mm. Single-row deep-groove ball bearing. Rubber seal on one side; compare the complete designation before ordering.

Bearing - 6000 2Z SKF

10 × 26 × 8 mm. single-row deep-groove ball bearing with non-contact metal shields on both sides. A low-friction shielded design for radial and limited axial loads in both directions.

Bearing - 6000 2Z P63E NTN

10 × 26 × 8 mm. NTN single-row deep groove ball bearing with non-contact steel shields on both sides, P6 accuracy, C3 radial clearance and electric-motor quality.

Bearing - 6000 2RS KINEX

10 × 26 × 8 mm. single-row deep-groove ball bearing with contact rubber seals on both sides. The closed design helps retain lubricant and protects the raceways from contamination and moisture.

Bearing - 6000 Z C6 ZKL

10 × 26 × 8 mm. is a single-row deep-groove ball bearing with one non-contact metal shield; the opposite side remains open. The design supports radial load and moderate axial loads in both directions while maintaining low friction. The shield helps retain lubricant and limits the entry of larger contaminants from one side. C6 is part of the complete designation and must be checked against the original….

Bearing - 6000 2Z FAG

10 × 26 × 8 mm. Deep groove ball bearing, shielded on both sides (2Z).

Bearing - 6000 2RS1 SKF

10 × 26 × 8 mm. deep-groove ball bearing is a single-row bearing with rubber seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage and common contaminants.

Bearing - 6000 2RSH C3 SKF

10 × 26 × 8 mm. deep groove ball bearing has contact rubber seals on both sides and greater-than-normal C3 radial internal clearance. The seals protect lubricant and raceways, while C3 provides allowance for clearance reduction caused by fits or operating temperature.