Bearings 17 × 35 × 10 mm

Bearing - 6003 ZKL

17 × 35 × 10 mm. single-row deep groove ball bearing in open design. A versatile bearing for radial and moderate axial loads in both directions, intended for arrangements providing their own lubrication and contamination protection.

Bearing - F 6003 2RS neu

17 × 35 × 10 mm. neu F 6003 2RS bearing for replacement use. Before ordering, compare the complete designation and verify the dimensions, design and fit with the original part. Confirm compatibility against neu documentation and the requirements of the specific application.

Bearing - 6003 2Z FLT

17 × 35 × 10 mm. Single-row deep groove ball bearing, shielded on both sides (2Z).

Bearing - 6003 2RS ZVL

17 × 35 × 10 mm. single-row deep-groove ball bearing with rubber seals on both sides. A versatile design for radial and limited axial loads in both directions, protected against common contaminants.

Bearing - 6003 2RSH C3 SKF

17 × 35 × 10 mm. SKF 6003-2RSH/C3 single-row deep groove ball bearing with greater C3 radial internal clearance and NBR contact seals on both sides. It is grease filled and protected against contamination.

Bearing - 6003 RS ZKL

17 × 35 × 10 mm. Single-row ZKL 6003-RS deep groove ball bearing with a rubber seal on one side. The sealed side helps protect the lubricant, while the opposite side remains open for the lubrication method defined by the bearing arrangement.

Bearing - 6003 C3 ZKL

17 × 35 × 10 mm. is an open single-row deep-groove ball bearing with greater-than-normal C3 radial internal clearance. It suits radial and limited axial loads where operating conditions require additional internal clearance.

Bearing - 6003 2Z ZVL

17 × 35 × 10 mm. is a single-row deep-groove ball bearing with two non-contact metal shields. Its versatile design supports radial load and moderate axial loads in both directions, while low friction makes it suitable for higher speeds. The shields help retain lubricant and limit the entry of larger contaminants. This is a general-purpose machine bearing, not a contact-sealed or watertight design.

Bearing - 6003 2RSH SKF

17 × 35 × 10 mm. single-row deep-groove ball bearing with high-performance contact seals on both sides for reliable protection of the lubricant and bearing interior.

Bearing - 6003 2Z ZKL

17 × 35 × 10 mm. single-row deep-groove ball bearing with metal shields on both sides for lubricant protection and low friction.

Bearing - 6003 2RS FAG

17 × 35 × 10 mm. deep-groove ball bearing is a single-row radial bearing with rubber seals on both sides. It carries radial loads and moderate axial forces in either direction. The 2RS design helps protect the internal rolling contact from dust and moisture while retaining lubricant inside the bearing.

Bearing - 6003 2RS MGK

17 × 35 × 10 mm. Single-row deep-groove ball bearing with rubber seals on both sides. Check the complete designation and suitability for the specific application.