Bearings 30 × 72 × 19 mm

Bearing - 6306 2RS TIMKEN

30 × 72 × 19 mm. Single-row deep-groove ball bearing with contact rubber seals on both sides (2RS). Check the complete designation before ordering.

Bearing - 6306 2RS ZKL

30 × 72 × 19 mm. Single-row deep-groove ball bearing. Rubber seals on both sides; compare the complete designation before ordering.

Bearing - 6306 Z ZKL

30 × 72 × 19 mm. Single-row deep groove ball bearing with a non-contact metal shield on one side. It carries radial and limited axial loads in both directions; the opposite side remains open.

Bearing - 6306 2RS1 C3 SKF

30 × 72 × 19 mm. Rubber seals on both sides. Greater C3 radial internal clearance. Robust SKF single-row deep groove ball bearing for demanding rotating assemblies.

Bearing - 6306 ZKL

30 × 72 × 19 mm. Open single-row deep-groove ball bearing for reliable radial and limited axial load carrying. Its versatile non-separable design suits a wide range of machinery applications.

Bearing - 6306 2Z C3 SKF

30 × 72 × 19 mm. SKF 6306-2Z/C3 single-row deep-groove ball bearing with non-contact metal shields on both sides and greater-than-normal C3 radial clearance.

Bearing - 6306 RS FLT

30 × 72 × 19 mm. Single-row deep groove ball bearing with a rubber seal on one side. This versatile design for radial and moderate axial loads combines protection with access for lubrication from the open side.

Bearing - 6306 2Z TIMKEN

30 × 72 × 19 mm. is a single-row deep-groove ball bearing with two non-contact metal shields. Its versatile design supports radial load and moderate axial loads in both directions, while low friction makes it suitable for higher speeds. The shields help retain lubricant and limit the entry of larger contaminants. This is a general-purpose machine bearing, not a contact-sealed or watertight design.

Bearing - 6306 2RS ZVL

30 × 72 × 19 mm. ZVL bearing for industrial applications. When replacing a part, always verify the complete designation, dimensions, design and application requirements against the manufacturer documentation.

Bearing - NU 306 ZKL

30 × 72 × 19 mm. Cylindrical roller bearing is a single-row radial bearing with high load capacity. The NU design has two integral flanges on the outer ring and an inner ring without flanges. It permits axial displacement of the shaft relative to the housing in both directions and is therefore primarily used as a non-locating bearing. It does not provide axial shaft location.

Bearing - NJ 306 FRB

30 × 72 × 19 mm. Single-row cylindrical roller bearing for high radial loads and axial location in one direction. The NJ design permits axial displacement of the shaft relative to the housing in the opposite direction; when replacing, compare the complete designation and required internal clearance.

Bearing - 1306 MGM

30 × 72 × 19 mm. MGM bearing for industrial applications. When replacing a part, always verify the complete designation, dimensions, design and application requirements against the manufacturer documentation.

Bearing - 6306 C3 SKF

30 × 72 × 19 mm. Greater radial internal clearance.

Bearing - 6306 N ZKL

30 × 72 × 19 mm. Rolling bearing for use in machinery and equipment.