Bearings 35 × 72 × 17 mm

Bearing - 6207 2RS ZKL

35 × 72 × 17 mm. single-row deep groove ball bearing with contact rubber seals on both sides. A compact solution for radial and moderate axial loads in both directions, protected against dust, contamination and lubricant loss.

Bearing - 7207 B TVP UA FAG

35 × 72 × 17 mm. single-row angular contact ball bearing with a 40° contact angle for combined radial and axial loads acting in one direction. The UA version is universally matchable and produces a small axial internal clearance in a bearing set.

Bearing - 6207 2RS SKF

35 × 72 × 17 mm. Rubber seals on both sides. Versatile SKF single-row deep groove ball bearing for reliable rotating assemblies.

Bearing - 6207 ZKL

35 × 72 × 17 mm. Single-row open deep groove ball bearing for radial loads and axial loads in both directions. The open design allows the lubrication method to be selected for the specific bearing arrangement.

Bearing - NJ 207 ZKL

35 × 72 × 17 mm. cylindrical roller bearing is a single-row radial bearing with high load capacity and rigidity. The NJ design has two guiding flanges on the outer ring and one on the inner ring, allowing it to carry radial load, locate the shaft axially in one direction and permit axial displacement in the opposite direction.

Bearing - 6207 2Z ZKL

35 × 72 × 17 mm. deep-groove ball bearing is a single-row radial bearing with non-contact metal shields on both sides. It supports radial loading and moderate axial forces in either direction. The 2Z shields help retain lubricant and keep out coarse contaminants while maintaining low friction and suitability for higher speeds.

Bearing - 6207 2Z SKF

35 × 72 × 17 mm. Metal shields on both sides.

Bearing - N 207 ZKL

35 × 72 × 17 mm. Single-row cylindrical roller bearing for high radial loads and accurate shaft guidance. The N design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.

Bearing - 6207 N ZKL

35 × 72 × 17 mm. Single-row deep-groove ball bearing for radial and axial loads in both directions. The N design has a snap-ring groove in the outer ring; when replacing, retain the complete designation and verify the axial locating method.

Bearing - 1207 K ZKL

35 × 72 × 17 mm. ZKL bearing for industrial applications. When replacing a part, always verify the complete designation, dimensions, design and application requirements against the manufacturer documentation.

Bearing - 6207 RS ZKL

35 × 72 × 17 mm. single-row deep groove ball bearing with a contact rubber seal on one side. Suitable for radial and moderate axial loads in both directions when one side requires improved protection from dust, contamination and lubricant loss.

Bearing - 1207 P6 ZKL

35 × 72 × 17 mm. ZKL bearing for industrial applications. When replacing a part, always verify the complete designation, dimensions, design and application requirements against the manufacturer documentation.

Bearing - NU 207 BP6 NA ZKL

35 × 72 × 17 mm. Technické provedení a kompatibilitu ověřte podle úplného označení výrobce a požadavků aplikace.

Bearing - 6207 C 2HRS C3 FAG

35 × 72 × 17 mm. FAG bearing for industrial applications. When replacing a part, always verify the complete designation, dimensions, design and application requirements against the manufacturer documentation.

Bearing - 6207 P63 ZKL

35 × 72 × 17 mm. Technické provedení a kompatibilitu ověřte podle úplného označení výrobce a požadavků aplikace.