Bearing - 2213 SKF

SS 61800 2Z neu stainless deep-groove ball bearing is a thin-section single-row bearing with non-contact metal shields on both sides. It combines low friction and protection of the factory lubricant against common dust, while the stainless design offers better corrosion resistance than conventional bearing steel.

25x52x15 mm

S 6205 2RS MTM deep-groove ball bearing is a single-row radial bearing with rubber seals on both sides. It carries radial loads and moderate axial forces in either direction. The S prefix forms part of the complete product designation.

40x80x18 mm

6208 2Z INA deep-groove ball bearing is a single-row radial bearing with non-contact metal shields on both sides. It supports radial loading and moderate axial forces in either direction. The 2Z shields help retain lubricant and keep out coarse contaminants while maintaining low friction and suitability for higher speeds.

30216 A ZKL tapered roller bearing is a separable single-row bearing for high radial loads combined with axial load in one direction. The A design offers increased load capacity and a higher limiting speed; clearance or preload is established during installation.

25x47x12 mm

6005 2RS SKF deep-groove ball bearing is a single-row radial bearing with rubber seals on both sides. It carries radial loads and moderate axial forces in either direction. The 2RS design helps protect the internal rolling contact from dust and moisture while retaining lubricant inside the bearing.

35x80x32.75 mm

32307 A KINEX tapered roller bearing is a robust single-row bearing for high radial loads combined with axial load in one direction. Its separable design allows the inner ring with rollers and the outer ring to be mounted independently. For a correct replacement, compare the complete designation including suffix A, the dimensions and required clearance with the original part.

25x42x20 mm

The GE 25 E 2RS ZVL radial spherical plain bearing has spherical sliding surfaces and rubber seals on both sides. It accommodates oscillating movement and misalignment while supporting high radial and combined loads.

Suitable for hydraulic cylinders, linkages, articulated mechanisms, agricultural and construction machinery. Its steel sliding surfaces require appropriate lubrication.

17x47x15.25 mm

30303 MGK tapered roller bearing is a single-row, separable bearing for combined radial and axial loads. Its tapered raceways carry axial load in one direction; bearings are normally paired where axial load must be supported in both directions.

35x62x14 mm

6007 2RS ZVL deep-groove ball bearing is a single-row radial bearing with rubber seals on both sides. It carries radial loads and moderate axial forces in either direction. The 2RS design helps protect the internal rolling contact from dust and moisture while retaining lubricant inside the bearing.

NA 4906 V DKF needle roller bearing is a full-complement radial bearing with machined outer and inner rings. The high number of needles provides high radial load capacity in a small radial cross-section; the design is intended for carefully lubricated arrangements at moderate speeds.

31305 A KINEX tapered roller bearing is a separable single-row bearing for high radial loads combined with axial load in one direction. Two bearings in an opposed arrangement are normally used when axial location is required in both directions.

40x90x23 mm

6308 FAG deep-groove ball bearing is a single-row radial bearing in the robust 63 dimension series for a 40 mm shaft. Deep raceways support radial loads and moderate axial forces in both directions with smooth running and low friction. The open design suits clean, correctly lubricated assemblies or machines that provide separate external protection.