Bearing - 31308 J2 SKF

40x80x18 mm

The 6208 2RS TIMKEN deep-groove ball bearing is a single-row radial bearing with contact rubber seals on both sides. The seals help retain grease and protect the raceways from common dust and moisture.

A versatile choice for electric motors, pumps, fans, gearboxes, conveyors and agricultural machinery. It supports radial loads and moderate axial forces in both directions.

20x52x22 mm

F 576208 3304 FAG double-row angular-contact ball bearing carries high radial loads together with axial forces in both directions. Two ball rows provide rigid axial location and the ability to support tilting moments in a compact unit. It suits positions where a single-row ball bearing does not provide sufficient axial capacity. F 576208 is a special FAG production designation; compare the complete code with the original part before substitution.

NA 4906 V DKF needle roller bearing is a full-complement radial bearing with machined outer and inner rings. The high number of needles provides high radial load capacity in a small radial cross-section; the design is intended for carefully lubricated arrangements at moderate speeds.

6213 2RSR ZVL deep-groove ball bearing is a single-row bearing with contact rubber seals on both sides. It carries radial loads and moderate axial loads in both directions, while the factory grease is protected against leakage and common contaminants.

50x110x27 mm

The 6310 C 2HRS C3 FAG deep-groove ball bearing is a Generation C single-row bearing with contact seals on both sides and C3 radial internal clearance. It is grease-filled and normally requires no relubrication under suitable operating conditions.

Suitable for motors, pumps, fans, gearboxes and industrial drives requiring contamination protection and additional internal clearance for temperature or tight fits.

45x100x25 mm

6309 2RS1 SKF deep-groove ball bearing is a single-row radial bearing with contact seals on both sides. It carries radial loads and moderate axial forces in either direction. The 2RS1 design protects the internal rolling contact from contaminants and helps retain lubricant inside the bearing.

HK 3520 CX drawn-cup needle roller bearing is an open-ended, thin-walled bearing without an inner ring. It provides high radial load capacity in a very small radial space; a suitably hardened and precision-ground shaft forms the inner raceway.

6213 C3 ZVL deep-groove ball bearing is an open single-row bearing with greater-than-normal C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and suits arrangements where interference fits or operating temperatures reduce internal clearance.

51105 ZKL single-direction thrust ball bearing is a separable bearing for axial load in one direction. It consists of a shaft washer, housing washer and ball-and-cage assembly and is not designed to carry radial load.

6x19x6 mm

626 2RSR ZWICKER miniature ball bearing is a single-row radial bearing for a 6 mm shaft with rubber seals on both sides. It carries radial load and lighter axial forces in either direction. The 2RSR design protects the lubricant and rolling contact in small drives and precision mechanisms.

110x170x38 mm

The 32022 X SKF single-row tapered roller bearing is a separable bearing for high radial loads combined with axial load in one direction. The cone assembly can be mounted separately from the outer ring, simplifying installation and maintenance.

This open, unsealed design requires suitable lubrication. Opposed bearing arrangements are normally used when axial loads must be supported in both directions.