Bearing - 7213 BECBP SKF

90x160x40 mm

Spherical roller bearing 22218 CCKW33 SKF with a tapered bore and W33 relubrication features. It carries high radial loads and axial loads in both directions, while its self-aligning design accommodates misalignment.

6014 2RSR FAG deep-groove ball bearing is a single-row bearing with RSR contact seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage, dust and moisture.

SS 6203 2RS neu stainless-steel deep-groove ball bearing is a single-row bearing with rubber seals on both sides. The stainless execution improves resistance to moisture and corrosion, while the seals protect the factory grease and bearing interior.

14x22x20 mm

Needle roller bearing without inner ring NK 14/20-XL INA for high radial loads in a compact space. The 14 mm dimension is the under-roller diameter, not a conventional bore; a suitably prepared shaft surface forms the inner raceway.

6016 2ZRC3 ZVL deep-groove ball bearing is a thin-section single-row bearing with non-contact metal shields on both sides (2ZR) and greater-than-normal C3 radial clearance. It combines low friction, high-speed capability and protection of the factory lubricant against common dust.

Deep groove ball bearing 6006 2Z C3 ZVL is a single-row bearing with metal shields on both sides and C3 radial internal clearance. It accommodates radial loads and moderate axial loads in both directions.

The non-contact 2Z shields limit contaminant ingress while maintaining low friction. C3 clearance is greater than Normal and must suit the temperature, speed and fit; it is not an automatic substitute for standard clearance.

31305 A KINEX tapered roller bearing is a separable single-row bearing for high radial loads combined with axial load in one direction. Two bearings in an opposed arrangement are normally used when axial location is required in both directions.

30216 A ZKL tapered roller bearing is a separable single-row bearing for high radial loads combined with axial load in one direction. The A design offers increased load capacity and a higher limiting speed; clearance or preload is established during installation.

6022 2Z C3 FAG deep-groove ball bearing is a single-row bearing with steel shields on both sides and C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and is suitable for higher-speed operation.

6314/C3VL0241 SKF INSOCOAT ball bearing is an open single-row deep groove bearing with C3 internal clearance and an electrically insulating coating on the outer ring. It helps prevent stray current from passing through the bearing and protects against electrical erosion damage.