Bearing - 7316 BEP SKF

32207 A ZKL tapered roller bearing is a separable single-row bearing for high radial loads combined with axial load in one direction. The A design offers increased load capacity and a higher limiting speed; clearance or preload is established during installation.

35x100x25 mm

Single-row cylindrical roller bearing NJ 407 ZKL for high radial loads with axial shaft location in one direction. The NJ design permits axial displacement in the opposite direction; when replacing, compare the complete designation and required internal clearance.

Deep groove ball bearing 6012 SKF is a single-row bearing in an open design. It accommodates radial loads and moderate axial loads in both directions and is suitable for accurate shaft support.

The open construction has no integral shields or seals, allowing direct lubricant access but requiring a clean or externally protected environment and a correctly designed lubrication system.

6305 2ZC3 SKF deep-groove ball bearing is a single-row bearing with steel shields on both sides and C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and is suitable for higher-speed operation.

6213 2RSR ZVL deep-groove ball bearing is a single-row bearing with contact rubber seals on both sides. It carries radial loads and moderate axial loads in both directions, while the factory grease is protected against leakage and common contaminants.

6213 C3 ZVL deep-groove ball bearing is an open single-row bearing with greater-than-normal C3 radial internal clearance. It carries radial loads and moderate axial loads in both directions and suits arrangements where interference fits or operating temperatures reduce internal clearance.

90x140x37 mm

The NN 3018 KMNA P51 ZKL double-row cylindrical roller bearing is a precision radial bearing with high rigidity and load capacity, intended particularly for machine-tool spindles and other demanding positions. Its tapered bore permits accurate radial-clearance adjustment during mounting.

The KMNA P51 configuration is part of the exact ZKL specification and must not be replaced by a standard NN 3018 without verifying every suffix.

31305 A KINEX tapered roller bearing is a separable single-row bearing for high radial loads combined with axial load in one direction. Two bearings in an opposed arrangement are normally used when axial location is required in both directions.

6014 2RSR FAG deep-groove ball bearing is a single-row bearing with RSR contact seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage, dust and moisture.