Bearing - ACB35X55X20 SNR

45x85x23 mm
INA SL182209-A-XL single-row full-complement cylindrical roller bearing in X-life design for very high radial loads and axial guidance in one direction.

65x140x51 mm

32313 SKF is a robust single-row tapered roller bearing for high combined radial and axial loads. Its separable design simplifies mounting and precise adjustment of clearance or preload.

35x80x21 mm

6307 2RS ZKL single-row deep-groove ball bearing with rubber seals on both sides for reliable operation and protection of the lubricant from contamination.

25x52x15 mm

6205 2RS CX is a single-row deep-groove ball bearing with rubber seals on both sides. It protects the lubricant and raceways from common contaminants while carrying radial and limited axial loads.

10x30x9 mm

6200 2RS ZVL is a single-row deep-groove ball bearing with contact rubber seals on both sides. It supports radial and limited axial loads while protecting the lubricant and raceways in commonly contaminated operation.

6x19x6 mm

626 ZKL is an open, single-row deep-groove ball bearing. It supports radial load and moderate axial loads in both directions, while its low-friction design makes it suitable for higher speeds.

The open design has no shields or seals, allowing easy lubricant access and effective heat dissipation. It therefore requires a clean arrangement with suitable lubrication or external sealing.

40x65x22 mm

NA 40 V ZKL is a full-complement needle roller bearing with an inner ring, dimensionally corresponding to type NKIS40. The V design uses a full complement of needles without a cage, providing high radial load capacity in a compact cross-section.

It is intended primarily for high radial loads at low to moderate speeds. The separate inner ring also permits use where the shaft cannot be prepared as a precision raceway.

70x110x25 mm

Robust single-row tapered roller bearing 32014 AX KLF ZVL for combined radial and one-direction axial loads. Its separable design simplifies installation and allows precise adjustment of operating clearance or preload.

17x47x14 mm

6303 2ZV neu is a single-row deep-groove ball bearing with metal shields on both sides. It combines low friction, protection against common solid contaminants and support for radial and limited axial loads.

17x35x10 mm

6003 2Z ZVL is a single-row deep-groove ball bearing with two non-contact metal shields. Its versatile design supports radial load and moderate axial loads in both directions, while low friction makes it suitable for higher speeds.

The shields help retain lubricant and limit the entry of larger contaminants. This is a general-purpose machine bearing, not a contact-sealed or watertight design.